779580
12
Verklein
Vergroot
Pagina terug
1/35
Pagina verder
12
7 Connections and Setup
7.1 Important Installation Information
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line is
disconnected from the network.
Use caution when installing or modifying telephone lines.
Temporarily disconnect any other equipment connected to the telephone.
7.2 Important Installation Guidelines
Install telephone near both a telephone jack and an electrical power outlet.
Avoid sources of noise, such as a window or a busy street, and electrical noise, such as
motors, microwave ovens and fluorescent lighting.
Avoid heat sources, such as heating air ducts, heating appliances, radiators and
direct sunlight.
Avoid areas of excessive moisture or extremely low temperature.
Avoid dusty locations.
Avoid other cordless telephones or personal computers.
CAUTION
Always disconnect all phone cords from the base unit before battery installation
or replacement.
NOTE
Certain other communications devices may also use the DECT 6.0 frequency for
communication, and, if not properly set, these devices may interfere with each other and/or
your new telephone. If you are concerned with interference, please refer to the owners manual
for these devices on how to properly set channels to avoid interference.
7.3 Installing the Phone
The Motorola ML1000 may be connected to either two 2-line (RJ14C) wall jacks or four single
line (RJ11C) wall jacks to accommodate all four lines. The Motorola ML1100 does not require
connection to telephone lines.
Choose an area near an electrical outlet and telephone wall jack. Your phone should be placed
on a level surface, such as a table top or desk.
Install 5 AAA-size alkaline batteries (not included) for backup power in the event of a power
failure. To open the battery door, find the tab on the top of the battery compartment. Push
down on the tab and pull away from the phone. A flat bladed screw driver may be needed.
Insert the batteries only as shown on the diagram inside the battery compartment.
NOTE
If the low battery appears in the display, you will need to replace the batteries to ensure unit
operation during a power failure.
IMPORTANT
If you are not going to use the telephone for more than 30 days, remove the batteries to avoid
battery leakage and damage to the unit.
Plug the AC power supply cord into the power jack on the back of the base and the other end
into an electrical outlet.
12

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Motorola ML1100 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Motorola ML1100 in de taal/talen: Engels als bijlage per email.

De handleiding is 1.44 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info