744397
16
Verklein
Vergroot
Pagina terug
1/21
Pagina verder
30
31
DK ENG
5. Re-stoking should normally be carried out while embers
still remain. Distribute the embers in the bottom, ensuring
that most of them are at the front of the stove.
6. Place 2 pieces of wood of approx. 0.7 kg each and ap-
prox. 25-30 cm long over the embers in a single layer, with
a distance of approx. 1 cm.
7. Open the air supply to maximum and close the door; the
fresh wood will then ignite within a couple of minutes.
8. Reduce the amount of combustion air to the desired po-
sition, and optimal combustion will continue until there are
glowing embers in the bed.
Make sure that there is always enough air (oxygen) to main-
tain clear, lasting ames when, and after, reducing the amount
of combustion air.
During the nominal test, the stoking interval was 60-70 min-
utes.
9. A new portion of wood can be added by repeating steps
5 & 6.
Important!
It is important that the fresh quantity of wood starts
to burn quickly. To ensure the fuel lights quickly, open
the combustion air to max. or leave the door ajar to
allow in the amount of air needed to light the wood.
If, however, the wood only smoulders, there will be a
strong build-up of smoke, which at worst can cause
an explosive ignition of the ue gases with the risk
of material damage and personal injury.
The stove door should normally be opened gently the rst 2-3 cm, then you should wait until
the pressure has equalised before opening the door all the way. This technique will prevent
smoke from getting out, particularly when there is a poor draugt.
The stove door should never be opened when the stove is being red vigorously.
Once the wood has burned out, it becomes glowing charcoall. If a good layer of embers has
already formed on top of a sucient layer of ash, the stove can keep warm for a very long
time, not least due to the favourable qualities of the cast iron.
We would strongly recommend that you do not leave your stove alit at night. It
harms the environment and constitutes very poor use of the wood as the gases
in the wood do not ignite at the low temperature, but settle as soot (unburned
gases) in the chimney and stove. Extreme conditions, such as poor draught in the
chimney, large quantities of wood or wet wood, may in the worst-case scenario
cause an explosive ignition.
When ring in the summer period, when there is minimal need for heat, the combustion
will be poor. The stove provides too much heat so the combustion should be reduced.
But always remember to make sure that there are lasting ames until the wood be-
comes charcoal. If you want a weaker re, stoke up using less wood.
If you re the stove using wet wood, a lot of the fuel’s thermal energy will be spent
forcing the water out of the wood, without releasing any heat to the stove. This
incomplete combustion results in a layer of soot being left in the stove, pipe and
chimney.
Comparison between ring with wood and oil:
Type of wood (moisture content 20%) No. of cubic metres per 1000 litre oil
Oak
Beech
Ash
Sycamore
Birch
Elm
Common spruce
Silver r
7.0
7.0
7.2
7.5
8.0
8.9
10.4
10.9
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Morso 6190 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Morso 6190 in de taal/talen: Engels, Deens als bijlage per email.

De handleiding is 0,42 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Morso 6190

Morso 6190 Gebruiksaanwijzing en installatiehandleiding - Nederlands - 36 pagina's

Morso 6190 Gebruiksaanwijzing en installatiehandleiding - Deutsch - 20 pagina's

Morso 6190 Gebruiksaanwijzing en installatiehandleiding - Français - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info