Notice for Operation
• Insert the measuring cup to the lid (align the arrow on the cup to the symbol
on the lid and turn it to position). Then press down the lid to the blender jar
to close. To open, pull up by the flap of the lid.
• If blender jar is not inserted to jar base properly, do not press it with force.
You may slightly rotate the drive coupling and insert the jar again. When
inserted properly, the unit will give a beep sound.
• During operation, close the lid tightly to avoid injuries due to spilling or
splashing of hot liquids.
• Wind part of the power cord underneath the unit base. Prevent rubber foot
from stepping on the power cord.
• When the food is too thick or there is too little liquid in the jar, the motor
will be dragged to a low speed or stop to operate. Hence, when blending
thick and sticky food, start blending from low to high speed. If it is still
unable to blend, disconnect the power and stir the food inside the jar using
a rubber stirrer to drive out the air trapped in food. Then close the lid and
switch on the blender to continue the operation.
• When overheating is sensed, the temperature monitoring system will be
activated and would stop the operation of the motor. In this case, put the
appliance in a place with good ventilation to cool it down for 45 minutes.
The system will be reset and you may resume the operation of the appliance.
• Keep hands and utensils out of the container while the motor is running to
prevent the possibility of severe personal injury and/or damage.
• In making hot beverage or soup (such as soy milk, porridge, bisque, etc.),
please ensure that the lid is secured tightly to the jar to prevent it from
falling. Please be advised to start the operation at low speed first and then
gradually increase the speed, or simply use the “Pulse” mode.
• When making sauces (eg. almond sauce, jam and sesame sauce), stuffing
and nuts, put in between 2 and 3 cups of ingredients. The amount should
neither be too large or too little. Keep the blending time below 2 min to
prevent any burnt smell due to overheating. Too much ingredients may lead
to overloading and overheating of the motor. In this case, wait till the motor
temperature falls before operating again.
• Please put liquid and soft food into the jar before putting in hard food or ice
cubes.
• When the operation finishes, please wait until the blade assembly comes to
a complete stop before taking up the blender jar.
• If you feel a burnt smell from the blender, stop the operation immediately. It
may be caused by the abrasion at the rubber cushion base if it is not properly
assembled.
• Do not operate continuously for over 10 minutes each time.
8
gebruiksaanwijzing Montana Mark I Engels 20-03-13 11:45 Pagina 8
