Power On - Auto Record
If this parameter is set the Mobius will start recording as soon as external USB power is
connected or the camera is turned on. The type of recording depends on the Power On
Default setting:
Video Mode 1 and Video Mode 2: If a Time-lapse Video parameter is set the camera
will begin recording a time-lapse video. Otherwise it will start recording a normal
video.
Photo Mode: If a Time-lapse Photos parameter is set the camera will begin recording
a sequence of time-lapse photos. Otherwise it will take a single photo and then enter
standby mode.
Recording can be stopped and started manually by pressing the Shutter button. The
camera will normally be turned off when USB power is removed, but, assuming the
camera's internal battery has sufficient power, there will be a delay before the recording
stops. The dalay can be set to zero (immediate), 10 seconds or disabled. If power is
reconnected during this delay, the camera will resume normal operation.
Power-Off Disconnect
This parameter will have no effect unless Power On - Auto Record is set to either 'External
Mode' or 'Both'.
Power-on Delay
This parameter gives the user the choice of having a 2-3 sec. delayed power-up, or an
instantaneous power-up with no delay. Note that the system requires about 2 seconds after
power-on until the buttons become active.
USB Data Port Charging
Enables or disables charging the internal battery when USB is connected and the camera is
turned on.
•
When disabled, charging will only occur when the camera is turned off.
•
When enabled, charging will occur as soon as the USB is connected.
►This parameter should be set to 'Disabled' when the camera is used with hand held
devices in order to avoid draining the device's battery.
Audio Volume
When the volume is turned OFF, the sound track is completely eliminated from the video
output stream in the selected video mode and will free up a nominal 7% video recording
space.
Time Lapse Photos
If Time Lapse Photos is enabled, Motion Detection must be disabled. Time Lapse photos
are taken with the camera in Photo-Mode (red LED). The rear LED will not blink when
Photo Mode has been configured to take Time-Lapse Photos with a time interval of less
than 2 seconds. Likewise, when Time Lapse Photos has been set to less than 2
seconds, photos will always be recorded without a time stamp.
►Time-Lapse delays of less than 2 secs. will be permanently reset to a minimal delay of 2
seconds as soon as Photo Mode (red LED) is selected on the camera with a Video-Out
monitor connected and a picture taken. You will need to set the parameter again if you wish
to restore the original value.
