583594
5
Verklein
Vergroot
Pagina terug
1/15
Pagina verder
Connecting the camera to the PC
Make sure a card is inserted and the camera is turned OFF if you want to access the
camera as an external device (disk drive, setup). Always connect the camera directly to the
PC. Do not use a USB hub.
You cannot record video or photos if the camera is connected to the PC as an external
drive.
Charging
Connect one end of the supplied standard USB cable to the camera.
Connect the other end to a USB, 5V DC power source (wall charger, PC or external
battery).
When the yellow LED turns on, briefly press the Power button to turn the camera
OFF.
NOTE: Charging when connected to a PC USB port can be toggled ON or OFF using the
setup program. When connecting to a Smartphone, you should turn this functionality OFF!
When charging, the green LED will be on, and it will turn off when the battery is fully
charged.
Charging takes about 2.5 hours for a fully discharged battery with the camera turned off and
connected to an external USB Charger. Batteries are not covered under warranty. Charging
is limited to around 140mA which offers the best possible long-term battery protection. If
charged with under-rated chargers or by using a USB hub without an additional power
supply, expect longer charging times. For optimum results, the charging voltage should be
+5V under load. Only use quality chargers capable of supplying 1000mA (1A) and a stable
voltage of at least 5V. Low quality chargers may not be able to supply enough current and
can lead to premature battery failure or, in the worst case, even destroy the camera.
A new hardware revision, released September 2014, is designed for 820mAh batteries
which have a higher capacity than the original 520mAh batteries. The new battery is
compatible with older hardware revisions but will take longer to charge. The new battery
allows recording for over 2 hours whereas the 520mAh battery will only last about 80
minutes. All boards stamped with 2014-08-19 or later also offer over-voltage protection up
to max. 24 Volt. If the external voltage exceeds 5V the camera will not start or charge.
Formatting
Standard formatting tools provided by the operating system are not always reliable. Also,
they do not optimize the SD card's performance. For optimal card performance it is
recommended to always use the camera's built-in formatter. Instructions for In-Camera
Formatting are outlined below under "In-Camera Formatting". Another excellent formatting
utility is "SD Formatter" which can be downloaded
from www.sdcard.org/downloads/formatter_4. This utility has been specifically designed for
formatting SD cards but will always format 64GB and greater cards to exFAT. Firmware
v2.03 - v2.10 requires all cards be formatted to FAT32 so 64GB/128GB cards must be in-
camera formatted (see below).
Automatic Power Off from Standby mode
If the camera is in Standby mode (Video Mode 1, Video Mode 2 or Photo Mode) you must
take a picture(s) or start a video recording within *30 seconds. The camera will
automatically turn off after *30 seconds of no activity.
*This value can be set using the setup program. Automatic Power Off can also disabled.
When the special A/V cable is connected, automatic power-off will be disabled. This
prevents signal loss during fpv use when Standby times out.
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Mobius ActionCam bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Mobius ActionCam in de taal/talen: Engels als bijlage per email.

De handleiding is 0,12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info