475282
116
Verklein
Vergroot
Pagina terug
1/128
Pagina verder
116 Appendices
General TV Operation
Symptom Remarks
14 A device does not respond to button presses
from the remote.
• RemotehasnotbeensetupforNetCommand®use.
• Theincorrectmanufacturerwasselectedduringsetup.SelecttheChangesetting
from the Setup menu and then the device to display the manufacturer selection.
Change if necessary.
• Thedeviceisnotsupportedandkeyshavenotbeenlearned.
• TherequestedfunctionisnotsupportedbyNetCommand.Verifythatthe
function is supported or keys are learned.
• TheIRemitterisincorrectlyplaced.MakesuretheIRemitterisfacingtheIR
sensor in the device.
• TheIRemitterisnotpluggedintotheIRemitterOutputNetCommand.
• TheIRemitterisfacingtheTVscreen,causingdoublesignals.BesurethattheIR
emitter cannot send to the TV.
15. Devices are grayed out in the Device Selection
menu or the PIP Selection menu.
• Arecordingisinprogress.Canceltherecordingtoselectthedevice.
• Digitalchannels,digitaldevices,memorycards,andPCscannotdisplayinthe
PIP.
16. Cannot see the A/V Receiver menu. The A/V Receiver is not connected to any video input of the TV. To
check the A/V Receiver menu, temporarily plug into an unused input of
the TV. Then select Review from the Setup Menu, turn the input On to
view the A/V Receiver menu.
17. When ChannelView™ list is displayed, information
appears incomplete
Available information is sent from the broadcaster or cable provider. No
other data is available.
18 TV is not responding after pulling out a memory
card during playback.
• TurntheTVofffor5to10secondsandthenturnitbackon.
• PressSTOPorwaituntilplaybackiscompletebeforeremovingmemorycard.
• ResettheTVusingtheSYSTEMRESETbutton.
19. TV can’t play or stop a memory card.
• NetCommandwasnotsetup.WithoutNetCommandenabled,youcanonlyuse
ENTER to play and CANCEL on the TV remote to control the memory cards. See
Appendix D for programming the remote control.
• TurntheTVoffandthenbackon.
20. Can’t see a thumbnail picture in the JPEG menu,
or can’t see a track/song name in the Playlist
menu.
File does not meet file standards for playback.
21. The message “Lamp will soon exceed...” keeps
displaying after the lamp has been replaced.
Reset the lamp reminder in the setup menu.
22. NetCommand unable to learn specific device
keys.
• DevicedoesnotuseIRformatforremotecontrolsignal.ITTandRFformats
cannot be learned.
• Roomlightingmayaffectthesignal.Havetheremotesveryclose(6inchesor
less) to the TV during Learning.
• IflearningaMitsubishiremotecontrol,makesureslideswitchisnotsettoTV
position.
• Some,butnotall,devicekeyfunctionscanbelearnedbyNetCommand.For
example, POWER and PLAY may be learned, but other functions may not
• Thesignalfromtheremotecontrolaynotbestrongenough.Insertfreshbatteries
and try Learning again.
Appendix J: Troubleshooting, continued
116

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Mitsubishi WD-73827 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Mitsubishi WD-73827 in de taal/talen: Engels als bijlage per email.

De handleiding is 7,8 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info