Safety notes
37
2.3 General safety notes
– Read through the safety notes and operating instructions in this manual carefully. Retain the operating
instructions for future reference. Miele does not assume liability or warranty in case of non-adherence to
these safety notes and operating instructions.
– Use the commercial dishwasher only after you have read and understood the operating instructions.
Allow the Miele Service Department to provide information about the operation and functioning of the
commercial dishwasher. Always operate the machine as described in these operating instructions.
– Train the operating personnel as regards handling the machine and inform them about the safety notes.
Repeat the training sessions at regular intervals to prevent accidents.
– For your safety, test the on-site residual-current circuit breaker (FI) regularly by pressing the test button.
– Close the on-site water stopcock after the work is complete.
– Switch off the on-site mains disconnector after the work is complete.
2.4 Electrical safety
The electrical safety of this machine is guaranteed only if it is connected to a correctly installed earthing cir-
cuit and a residual-current circuit breaker. It is very important that this basic safety requirement is tested and
in case of doubt the installation must be checked by a qualified electrician.
The manufacturer cannot be held responsible for damage caused by a missing or broken earthing circuit
(e.g. electrical shock).
2.5 Safety notes for maintenance and repairs
– Maintenance work and repairs may only be performed by authorised Miele service technicians. Improper
maintenance or repairs may cause significant danger for the user, for which Miele is not liable.
– When performing installation and maintenance work, disconnect the machine from the power network.
Power consumers (heating element, frequency inverter, ...) are under voltage until the on-site mains dis-
connector has been operated.
– Only original Miele spare parts may be used for maintenance and repairs. If original spare parts are not
used, the warranty is invalidated.
– A damaged or leaking machine can endanger your safety. In case of defects, switch off the machine
immediately. Switch off the on-site mains disconnector (main switch). Only then is the machine without
power.
– Do not operate a damaged machine. In case of defects resulting from an unknown cause, switch off the
machine, and switch it on again only when the defect has been rectified.
– Contact your installer and/or electrician if the on-site water and/or electricity supply is the cause of the
malfunction.
– Notify an authorised service technician or your retailer if another fault has occurred.
– If the mains cable of this machine is damaged, it must be replaced by the manufacturer or his service
agent or similar qualified person in order to prevent hazards. The mains cable must be H07 RN-F type or
equivalent.
– Do not spray the machine and the surrounding area (panels, base) using a water hose, steam cleaner or
high-pressure cleaner.
– Ensure that the base of the machine is not flooded when cleaning the floor in order to prevent an
uncontrolled inflow of water.
