579673
14
Verklein
Vergroot
Pagina terug
1/54
Pagina verder


  
The radio doesn’t switch on
The battery pack is discharged and/or has not been
installed correctly.
Verify that the battery pack is charged and that it has
been correctly installed.
The radio switches off shortly after it has
been switched on
Discharged battery pack. Recharge the battery pack.
The battery pack does not recharge
The battery-charger has not been connected or installed
correctly.
Inspect the connections of the battery-charger and the
installation of the batteries.
The radio switches on but is unable to
receive signals
The site of installation is too shielded. Move to an another area.
The volume is too low Adjust the volume level.
Incorrect CTCSS or DCS
Check that the CTCSS tone or DCS code corresponds
to the one set by the parties you are communicating
with.
Noise is always present in reception mode The Monitor function is enabled. Disable the Monitor function.
It is not possible to communicate with
other parties
An incorrect radio channel has been selected.
Select the same radio channel used by the parties you
are communicating with.
The radio is installed in a shielded area or is too far from
the party you are communicating with
Move to another area.
Incorrect CTCSS or DCS
Check that the CTCSS tone or DCS code corresponds
to the one set by the parties you are communicating
with.
Reception is fragmented and/or disturbed
The signal is very weak.
Try temporarily disabling the Squelch by means of the
Monitor feature.
The transmission distance is excessive and/or there are
obstacles in the transmission path
Move closer to the party you are communicating with or
to another area.
Other parties are using the same channel
Check the trafc on the radio channel by means of the
Monitorfeature and select another channel if required.
The radio has been installed too close to equipment that
causes interference (televisions, computers, etc.)
Increase the distance between the radio and this
equipment.
Transmission is not always possible
The channel is used by an excessive number of parties
or the transmission has been barred due to a busy
channel.
Select another channel. Ask the radio link provider to
disable the block due to busy channel.
VOX causes the radio to accidentally
enable transmission
The sensitivity and/or environmental
noise is too high.
Reduce the VOX sensitivity.
The VOX feature requires speaking in a
loud voice
The sensitivity is too low.
If the environmental noise is not high, increase the
sensitivity or use an optional microphone.
The autonomy of the battery pack is limited Commission time is too high.
Try reducing the transmission time and/or using a low
power.
Logic related faults (unreadable displayed
symbols, functions blocked, etc.)
Incorrect setting caused by a problem with the power
supply.
Recharge the battery pack
14

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Midland G11-S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Midland G11-S in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 4,55 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info