16
1 Screw the faucet adapter onto (or into) the faucet tap. Check for leaks (use Teflon tape to eliminate if
necessary).
2. Connect the six-sided connection of the drain hose to the drain port connection on the back of the
dishwasher cabinet. Do not over-tighten (to avoid damage to threads).
3.Connect the star-shaped connection of the inlet hose to the inlet port on the back of the dishwasher
cabinet. Do not over-tighten (to avoid damage to threads).
4.Connect the circular connection of the drain hose onto the longer (bottom) male connection on the quick
connect.
5.Connect the circular connection of the inlet hose onto the shorter (top) male connection on the quick
connect.
6.Attach the quick connect onto the faucet adapter, by pulling down the outer locking collar on the quick
connect, while pushing the quick connect upward onto the faucet adapter.
7.When the quick connect snaps onto the faucet adapter, release the locking collar. Verify the connection
is secure.
8. Slowly open the hot water line and check for any sign of water leaks at all hose connections. If leaks are
located, immediately close the water supply and repair the hose connections.
Important
1. Once you open the water supply line, (even if it is closed immediately thereafter), the inlet hose will be
pressurized.
2. To relieve water pressure from inside the inlet hose, (make sure the water line (faucet) is closed): press
and hold the red pressure relief button on the quick connect until the flow of water stops.
WARNING
NOTE:
Hard water conditions will adversely affect the washing performance of your dishwasher. Hard
water conditions will also contribute to 'lime' (white film substance) deposits and/or 'scaling' on the
stainless steel surface of the dishwasher tub and heater element, located in the sump underneath
the removable filter screen. To assist in minimizing these conditions, it is recommended to
periodically operate/rinse the inside of the dishwasher (empty) using 1 cup of white vinegar at least
once a week.
Disconnecting your Dishwasher
1.Shut off the water supply at the faucet.
2.Disconnect the power supply cord
FAILURE TO RELIEVE WATER PRESSURE, BEFORE DISCONNECTING THE QUICK-CONNECT
FROM THE FAUCET, WILL RESULT IN BACK-PRESSURE OVER-SPRAY. THE TEMPERATURE OF
INCOMINGWATER CAN BE VERY HOT, AND BACK-PRESSURE OVER-SPRAY COULD CAUSE
SEVERE BURNS AND/OR SCALDING.
DANGER
DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE SUPERVISION OF CHILDREN IS
ALWAYS IMPORTANT AROUND APPLIANCES.
Start of dishwasherStart of dishwasher
The following things should be checked before starting the dishwasher.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Attention:Attention:
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
