• Let the appliance slide over the skin in direction of growth of hair by applying gently
pressure on the appliance. (Fig. 8).
• Recommendation: Strech the skin with the other hand while sliding over the razor
head. Let the appliance slide gently and without too much pressure
Precisely shortening of the hair
• If you use the applaince fort he first time just shorten a smal area. To get used to the
cutting length of the comb attachment. It is recommended to use the longest cutting
length (approx. 6 mm) first and then when getting used to the appliance change to
shorter level (4 or 2 mm).
• Fix the comb attachment at the razor head.It must be engaged into the small support.
on both sides. (Fig. 9). In order to change cuttiing length push the adjustment switch
upward or downward, depending which level is desired. Check the cutting length
indication. Fig.10).
• Switch on the appliance by pressing the On/Off switch into position „On“.
• Shorten the hair by sliding it against the direction of hair growth. (Fig.11).
Recommendations
• To get the hair evenly short let the appliance slide slowly and gently through the hair.
Do not apply too much pressure.
• Before use ensure that the appliance is clean and no residues of hair is between the
blades (12/5) cause this could badly affect the cutting performance. Therefore remove
the comb attachment and clean the blades (12/5) with the small brush provided.
Using the ergonomical handle
• The ergonomical handle is recommended for body areas which are difficult to access
and also for comfortable operation. Remove the cap at the back of the appliance insert
the ergonomical handle while pressing both lugs at the sides (Fig. 12). Ensure that it is
fixed properly.
• The handle can be folded out (ideal for use at the legs) as well as retracted e.g. for
use at the back (Fig. 13).
• To remove the ergonomical handle press both lugs at the sides and pull out. Then fix
the cap at the back of the appliance again (Fig. 14).
Adjustment of the cutting length of the comb attachment
The comb attachment provides 3 different cutting lengths:
• Level 1: approx. 2 mm
• Level 2: approx. 4 mm
• Level 3: approx. 6 mm
Cleaning and maintenance
• Before cleaning ensure thet it is switched off and unplugged.
• Remove the comb attachment.
• Clean the housing with a soft dry cloth only.
• Clena the blade with the small brush provided. (Fig. 15).
• Remove the razor head by pulling it outward and clean the blades with the small brush
provided. (Fig. 16).
