OAlways comply with the manufacturer's
installation and operating instructions forthe
child restraint system used.
OMake sure that thechild's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
®When installing a LATCH-type (ISOFIX) child
restraint system, also observethefollowing:
OWhen using a bab
When using a baby car seat in wy car seat in weight greight groupoup
0/0+ and a r0/0+ and a rearwearwarard-fd-facing cacing child rhild resestrtraintaint
systsystem in wem in weight greight group I on a roup I on a rear seatear seat::
adjust the front seat so that the seat does
not touch thechild restraint system.
OWhen using a fWhen using a forworwarard-fd-facing cacing child rhild resestrtraintaint
systsystem in wem in weight greight group I:oup I: remove the head
restraint from therespective seat, if possible.
In addition, the backrest of thechild restraint
system must lie as at as possible against
the backrest of thevehicle seat.
Aer thechild restraint system has been
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
OIf the head restraint of thechild seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting forchild restraint sys-
tems in weight group II or III.
Contact with theroof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
OThe child restraint system must not be put
under strain between theroof and the seat
cushion and/or be installed facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
OThe child restraint system must not be put
under strain by the head restraint. Adjust the
head restraints as appropriate. 1LATCH-type (ISOFIX) mounting bracket
#Before every journey, make sure that the
LATCH-type (ISOFIX) child restraint system is
correctly engaged in both mounting brackets
in thevehicle.
5858 Occupant safety
