Handleiding Melitta caffeo n 66 e 911 (pagina 16 van 47) (Nederlands, Duits, Engels, Frans, Deens, Zweeds)

362055

Verklein

Vergroot

Pagina terug

1/47

Pagina verder

27 28

Cleaning

12.2 Cleaning the Easy Cappuccino

Milk deposits in the Easy Cappuccino (15) can

be easily removed. Unscrew the lower base

of the Easy Cappuccino. Remove the whisk

wheel by pressing it from the top out of the

steam pipe, Fig. Q. Traces of milk on the steam

pipe and whisk wheel can now be rinsed,

wiped off or removed in the dishwasher. Then

put back the whisk wheel into the steam pipe

from below until it snaps into place. Secure

both to the milk frother.

Make sure the seal of the Easy Cappuccino

always sits firmly.

12.3 Cleaning the grinder

The grinder does not usually need to be

cleaned. Now and again, larger residues can

be removed with a small brush. Never clean

the grinder with water.

12.4 Integrated cleaning programme

This programme is for the complete removal

of residues and traces of grease which cannot

be removed by hand. We recommend monthly

cleaning or after some 200 brewed cups – at

the latest when the appliance requests you to

do so. The cleaning display lights up.

Tip: Use the specially developed Melitta

cleaning tabs for fully automatic coffeemakers

and single cup machines, as these are adapted

exactly to your Melitta

CAFFEO

Turn the function controller (21) to

“Cleaning”.

Fill the water reservoir (8) to capacity

(1.5 litres).

Fig. R Set the coffee bean container (2)

to ground coffee operation and insert the

cleaning tab into the ground coffee chute.

After inserting, confirm by pressing the start

key (23).

Empty the coffee grounds container and

replace. Then pull out the container (12) to

the middle of the drip tray, where it can

collect the cleaning water.

Now press the start key (23).

The cleaning programme can no longer be

interrupted. There are 6 rinsing cycles with

breaks. The programme lasts some 8 minutes.

The cleaning symbol (18) flashes during the

whole operation.

When the programme is over, the “Coffee

grounds container” symbol appears in the

display. Empty the coffee grounds container

and replace. Confirm the end of the cleaning

programme by pressing the start key (23).

After putting into serving operation, the

coffeemaker is ready for use again.

12.5 Cleaning the brewing unit

We recommend cleaning the brewing unit

from time to time. This is how to proceed:

Shut down the appliance.

Fig. S Open the service door (7).

Fig. T Press the red safety lever on the right

upwards until it stops.

Fig. U Keep the red safety knob at top left

pressed with your left hand. At the same

time, use your right hand to press down

the interlocking key at the front of the

brewing unit. Pull the brewing unit out to

the front, Fig. V.

Fig. W Turn the red handle at the side of

the brewing unit to open it.

Now you can thoroughly clean the brewing

unit under running water.

After cleaning, turn back the red handle.

Fig. T Put the brewing unit back into the

coffeemaker. After this, press down the

safety lever and close the service door.

The appliance can be switched on again.

Depending on use and water hardness, the

appliance needs to be decalcified every 4-6

weeks. When the decalcifying display (19)

lights up, this means that the appliance must

be decalcified. Coffee can still be made for a

number of brews. After that, no more coffee

can be supplied (to protect the appliance) and

it must be decalcified.

Caution: Do not use vinegar or other decal-

cifying agents not recommended by Melitta

Tip: Use the specially developed decalcifying

agents from Melitta

for automatic coffee-

makers and single cup machines, as these are

exactly adapted to your Melitta

CAFFEO

The automatic decalcifying programme takes

around 30 minutes and consists of two phases.

Proceed as follows:

Phase 1:

Turn the function controller (21) to

“Decalcifying” and confirm with Start.

The “water reservoir” symbol (18) lights up

and the bars for brewing strength and

water quantity are extinguished. Dissolve

the decalcifying agent in 0.5

litres of water

and pour the solution into the water

reservoir (8), Fig. X.

Please follow the instructions for use

of your decalcifying agent.

Press the start key (23).

The “Coffee grounds container” symbol (18)

lights up. Empty the coffee grounds

container and replace. Then pull out the

container (12) to the middle of the drip tray

in order to collect the decalcifying solution.

Please place another receptacle under the

steam/boiling water nozzle (15).

Then press the start key (23).

When the “water reservoir” symbol flashes,

open the steam/hot water valve (17). Roughly

the quantity of one cup of water is pumped

into the receptacle. Then shut off the valve

and confirm with Start (23).

The coffee outlet is then automatically de-

scaled.

The decalcifying display (18) flashes

during the whole decalcifying operation.

Various cleaning cycles with breaks are now

run. This lasts some 25 minutes.

When the “water reservoir” symbol lights up,

it is time for Phase 2 – a rinsing cycle. Phase

2 lasts about 5 minutes.

Phase 2:

The “water reservoir” symbol (18) lights up.

Rinse the water reservoir (8) and fill to

capacity with fresh water (1.5 litres). Then

re-fit the reservoir to the coffeemaker.

Press the start key (23).

The “Coffee grounds container” symbol (18)

lights up. Empty the coffee grounds

container (12) and receptacle and place both

under the coffee outlet (13) and steam/hot

water outlet (15) again.

Now press the start key (23).

When the “water reservoir” symbol (18)

flashes, briefly open the knob for steam/hot

water (17) and – as soon as the milk frother

has been rinsed – re-tighten it. Roughly the

quantity of one cup of water is pumped

into the receptacle.

Confirm with Start (23).

The appliance is now rinsed thoroughly to

ensure complete removal of the decalcifying

solution. Decalcifying is over when no further

water is dispensed from the coffee outlet.

Empty the coffee grounds container and

confirm when replaced with Start (23).

Refill the water reservoir. The decalcifying

symbol is extinguished in the display when

the function controller is set to serving.

We would advise not drinking the first cup of

coffee, in order to be absolutely sure that

nothing remains of the decalcifying solution

in the coffeemaker.

Decalcifying

ENGLISH

Melitta caffeo n 66 e 911 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info