29
Timer
If the standby indicator (26) comes
on, you can adjust the appliance to
automatically switch on after 1-24
hours.
Press the timer button (31) one or more
times until the required number of
hoursashinthedisplay.Afterafew
seconds, the number of hours will be
permanently displayed and once the
set number of hours has passed, the
appliance will come on.
If the appliance is on, you can set it to
automatically turn off after 1-24 hours.
Press the timer button (31) one or more
times until the required number of
hoursashinthedisplay.Afterafew
seconds, the number of hours will be
permanently displayed and once the
set number of hours has passed, the
appliance will go off.
Night setting for cooling
If the appliance is on and you have
selected cooling, you can turn the night
setting on by pressing the night setting
button (34) on the remote control so
that the night setting indicator (25)
comes on. On the night setting, the fan
speed is low and the temperature is
increased by 1 °C after 1 hour and by
an additional 1 °C after 2 hours.
The night setting is cancelled if you
change function, if the appliance
goes into standby or if the water
tank is full. The night setting cannot
be used together with ventilation or
dehumidication.
Full water tank
The appliance is equipped with an
automatic evaporation system which
both increases the cooling effect and
saves energy. If the water tank is full, an
acoustic signal is heard and the water
tank full indicator (19) comes on. The
appliance then automatically goes into
standby and cannot be turned on again
until the water tank has been emptied.
Remove the plug from the socket.
Place a suitable container of at least
3 litres under the water outlet on the
rear of the appliance. Unscrew the plug
cap (11) and remove the rubber plug
(10). Allow the water to run into the
container. Replace the rubber plug and
screw the plug cap back on.
CLEANING
When cleaning the appliance, you
should pay attention to the following:
- Do not use scouring pads, steel
wool or any form of strong solvents
or abrasive cleaning agents to
clean the appliance, as they can
damage the external surfaces of the
appliance.
- IMPORTANT! Allow the appliance to
dry fully after cleaning before using
again.
- Removethelters(6,9)fromtheir
holders and gently wash them in
warm water every fourteen days.
Allow them to dry fully in a location
away from direct sunlight before
replacing them. The appliance must
notbeusedwithoutlters.
- Ensure the appliance is clean and
dry before storage.
