661793
16
Verklein
Vergroot
Pagina terug
1/18
Pagina verder
16 [EN]
9. TROUBLESHOOTING AND FAULT CODES
If Zambezi displays C1, C2, C3, C4 or if the temperature and relative humidity readout continuously flickers then consult
your Meaco approved after sales service centre.
Problem
Cause
Solution
The unit does not work.
The power is not connected.
Insert the plug into the wall outlet.
The device does not
dehumidify.
The water container is full.
Remove the water from the container.
The water container has not been replaced correctly.
Place the water container in the correct position.
The air filter is clogged.
Clean the air filter.
The temperature in the room where the dehumidifier is
operating is too low.
The machine does not dehumidify below 1°C, it is highly
unlikely at that temperature that there is any moisture to
remove anyway.
The relative humidity in the room where the dehumidifier
is operating is too low.
The dehumidifier dries down to the target relative
humidity set and then goes into fan only mode until the
relative humidity goes above the set point again.
The dehumidifier works,
but reduces the relative
humidity
insufficiently/there is little
water in the water tank.
The house is too large. This dehumidifier can dry up to
about a small five bedroom house.
We recommend using a dehumidi
fier with a greater
capacity.
There are too many sources of moisture. Bathing,
washing, drying clothes and cooking all puts moisture into
the air.
Portable
gas heating can add too much moisture
into the air for a dehumidifier.
We recommend using a dehu
midifier with a greater
capacity. Consider using a different heat source to a
portable
gas heater.
There is too much ventilation.
Reduce ventilation (e.g. close windows and shut doors.)
The air filter is blocked and the reduce air flow is effecting
performance.
Clean the air filter.
The windows were clear
and now condensation
has returned.
The outside air temperature has dropped and the
windows are colder.
Set the dehumidifier to a lower target relative humidity so
that there is less moisture in the a
ir.
Increasing the fan
speed will also increase the amount of water collected.
I cannot remove the
condensation from my
windows, even in 40%rh
mode.
The surface temperature of the windows is too low for a
dehumidifier to prevent condensation. Common wit
h
single glazed windows and when the outside air
temperature drops below freezing.
Keep running the dehumidifier on 40%rh 24 hours a day
and when the air temperature outside increases the
windows should clear of condensation.
Increasing the fan speed will also increase the amount of
water collected.
Dehumidifier is blowing
out warm air.
The dried air is past over a heating element before it is
blown into the room as part of the dehumidification
process.
This is normal, a dehumidifier is not an air coole
r.
Knocking noise coming
from the dehumidifier
Motor that rotates the desiccant wheel is low on
lubrication.
Run the dehumidifier in Laundry mode for two days to
increase the lubrication, if fault persists then call Meaco.
Water not draining down
the hos
e
Hose is fitted for continuous drainage but the water still
goes into the tank.
Negative air pressure in the room is pulling the water
back into the dehumidifier overflow. Insert a 4mm hole
into the top of the tube 30mm down from the spout. This
will in
troduce air into the tube and balance out the air
pressure.
Dehumidifier leaks water
onto the floor
Usually means that the dehumidifier is not on a level
surface or that the filter has not been cleaned often
enough and dirt has fallen into the dehumidifie
r.
You can also check that the water bucket is not cracked
by filling it with water and placing it on kitchen paper on
the kitchen side.
Clean away any dirt that is blocking the water as per
section seven.
Machine not switching off
and on in the usual 30
minute pattern
Temperature and relative humidity sensor that reads the
room reading is unable to read the correct readings.
Clean the filter and blow the air sensor with a hair dryer
on fast setting to clear the sensor of dirt. Unplug the
dehumidifier for 10 minutes to reset it’s circuits and then
turn back on.
Unit only works in
Laundry mode and
Laundry light stays on or
flashes.
If the humidity sensor is faulty then
the dehumidifier will
only run in Laundry mode.
Try clearing the sensor as per above line, if that fails then
call Meaco for a repair.
16

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Meaco-DD8L-Zambezi

Zoeken resetten

  • Hoe kan ik het handvat van de Zambezi er af halen om de kas te openen voor andere elektrische kabel eventueel te vervangen of uit te testen daar het toestel geen stroom krijgt. Gesteld op 4-6-2020 om 22:45

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Meaco DD8L Zambezi bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Meaco DD8L Zambezi in de taal/talen: Engels als bijlage per email.

De handleiding is 2,23 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Meaco DD8L Zambezi

Meaco DD8L Zambezi Gebruiksaanwijzing - Nederlands - 19 pagina's

Meaco DD8L Zambezi Gebruiksaanwijzing - Deutsch - 19 pagina's

Meaco DD8L Zambezi Gebruiksaanwijzing - Français - 19 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info