10
combine this setting with heavy distortion and high Treble
and Bass settings you can get a killer ‘thrash’ tone, perfect
for brutal rhythms and vicious leads. By turning the
Contour fully anti-clockwise you can get some great
fusion type tones. We would suggest that you spend some
time experimenting with this control to find the optimum
setting for your style, if you’re not sure, simply leave the
control set to 12 o’clock.
15. Volume
Controls the volume of Overdrive 2 channel.
-Overdrive Equalisation-
The following Bass, Middle and Treble controls
are used for both Overdrive channels.
16. Bass
This controls the amount of bottom end or low
frequencies in your guitar tone. When using a heavily
distorted tone, increasing the bass will generally make
the tone darker and heavier.
17. Middle
The middle frequencies are those which generally
affect the size of your sound. By increasing the
amount of middle in your tone your guitar will sound
fatter, conversly reducing the middle frequencies will
make your guitar sound thinner.
18. Treble
By adjusting the Treble control you can add or
take away the higher frequencies in your guitar tone.
By turning up the Treble control and increasing those
high frequencies you will make your guitar sound
more cutting.
19. Power Dimension Switch
The Power Dimension Switch is designed for use
in situations where you have set your amp to get your
sound but it is simply too loud for the given situation.
Its function is to emulate, at lower volume levels the
extra saturation found when playing through a
transformer and valve power stage pushed to the limit.
20. FX Loop Level
It is possible to adjust the FX Loop Level 10dB
to ensure that the FX Loop is perfectly suited to the
type of effects unit that you are using, i.e. rack
mounted or floor pedal.
21. FX Mix
When using the FX Loop on the rear panel the FX
Mix allows you to dial in the desired amount of effected
signal into your overall sound. Turning the control fully
clockwise will result in a fully effected sound, i.e. no dry
signal and turning the control fully anti-clockwise will
result in a fully dry sound.
-Reverb-
Adding reverb to your guitar tone will add ambience
and size, giving the effect of playing in a large empty
room or hall. The VS100R, VS100H & VS102R feature
separate reverb levels for the Clean and Overdrive
channels giving you greater control over your sound.
22. Clean Reverb
Dictates the amount of reverb on the Clean
Channel.
23. Overdrive Reverb
Controls the amount of reverb on the Overdrive
Channel.
24. Power Switch
Switches the mains power to the amplifier.
Rear Panel Features
1. Mains Input
For connection to mains. Always ensure that a good
quality lead and plug are used and wired in accordance
with your country’s regulations.
2. Head Phone Jack
For connection of headphones. Connection of
headphones will automatically cut off internal speaker.
3. & 4. Loudspeaker Jacks
For connection to external loudspeakers. The
minimum operating impedance for the VS100R, VS100H
& VS102R is 4 Ohms. The internal speaker on the
VS100R/VS102R is rated at 8 Ohms, therefore if using an
external speaker in conjunction with the internal speaker,
the external speaker should be rated at 8 Ohms.
5. Footswitch Jack
For connection of footswitch. Both the
VS100R/VS102R and VS100H are three channel
amplifiers and it is possible to switch between the Clean
Channel and Overdrive 1 and Overdrive 2 Channels via
the footswitch which also features LED’s to indicate
status.
6. Effects Return Jack
For connection from the output of an external
effects processor.
7. Effects Send Jack
For connection to the input of an external effects
processor.
8. D.I. Jack
For connection to recording or P.A. equipment,
featuring Marshall’s acclaimed Speaker Emulation
circuitry as featured on the JTM60 range.
ENGLISH
