9
ENGLISHFRANÇAIS
Functions available with AL-Bus System Connection
The numbers of controls and buttons on the main unit are enclosed in
k, and those on the remote control are enclosed in Ǣ.
1. Synchronized power ON/OFF
Switching the POWER switch !0/z ON/OFF also turns ON/OFF the
power of the tape deck connected through the bus system
connection.
2. Synchronized door open/close
Pressing the DOOR button , of the remote control opens or closes
the doors of the components in the system.
3. Auto operation
When the tape deck is operated, the system switches over
automatically to the component which is playing.
4. Simple connection
The system can be connected very easily with a small number of
cables.
PLAYING A PROGRAMME SOURCE
Normal play
1.
Set the VOLUME control @5/n to the minimum position.
2. Press the POWER switch !0/z to turn the power ON.
3. Press the optimum function button !5, !6/x for the source to be
played by referring to the table below.
4. Start playing the source component.
Adjust the listening volume with the VOLUME control @5/n.
To record sound onto a tape or MD:
Use the following procedure when recording, for example, CD onto a
cassette tape or MD.
1. Press the function button x of the source to be recorded. In this
example, press the CD function button.
2. Operate the CD player.
3. Operate the tape deck to record the CD onto a cassette tape.
The recorded sound will be the same as that reproduced through
the speakers.
2. Loading batteries
Batteries in this remote control unit have a life of approximately 1 year
under normal operating conditions. If the remote control unit is not
going to be used for an extended period of time, remove the batteries.
Also, if you notice that the batteries are starting to run down, replace
them as soon as possible.
1) Remove the battery cover.
2) Insert the batteries with correct ѿ/Ҁ orientation.
3) Close the battery cover until it clicks shut.
The battery life is about 1 year under normal use.
The life is variable depending on the operating condition. If the unit is
not to be used for a long period of time, be sure to take out the battery
from the unit.
The RC2020CR Remote control is capable of controlling Marantz
system components equipped with the D-Bus or AL-Bus jacks, such as
a MD Deck and tape deck as well as this unit. Refer to “Connection of
D-BUS Remote Control Bus” on page 5 or to “System Connection
through AL-Bus” on page 5 and make the appropriate connections
before proceeding to system control operation.
An example procedure for system operation is described below. Here,
the case in which a TAPE Deck is connected to this unit through the AL-
Bus is taken as an example.
1. Press the POWER switch z to turn the power of this unit ON.
2. Press the TAPE function button x to set the remote control to TAPE
mode.
3. Press the PLAY control button b to play the tape deck.
4. Press the VOLUME e/ȕ buttons n to adjust the listening volume.
5. Press the STOP control button b to stop the tape deck.
6. Press the POWER switch z to turn the power OFF.
¼ As described above, pressing one of the FUNCTION buttons x of
the remote control switches the remote control mode so that the CD,
tape deck or MD player can be controlled (Play, Stop, Pause, etc.).
Remote control unit (RC2020CR)
Rear side
Two AAA-size (R03) batteries
Source to be played Function button !5, !6/x
CD CD
FM/AM FM/AM
AUX (second tape deck, etc.) AUX
MD player MD
Cassette tape deck TAPE
