6574
27
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
24
ENGLISH
OTHER FUNCTION
TV AUTO ON/OFF FUNCTION
This function allows the component connected to
the TV-VIDEO in jack to control the power (ON/
OFF) to the SR5400.
AUTO POWER ON
1.
Be sure the TV auto mode is ENABLED.
(Refer page 18 : System Setup)
2.
Connect your TV TUNER (etc) to the TV-
VIDEO in terminal. Be sure to connect the
VIDEO input.
3.
Turn OFF the power to the TV TUNER and
the SR5400.
4.
Turn ON the TV TUNER and tune in a receivable
station.
5.
When the station is received, the SR5400
turns ON and TV is selected automatically.
AUTO POWER OFF
1.
In the above situation, turn the TV TUNER
OFF or select a channel that does not contain
any broadcast.
2.
The power to the SR5400 switches to STANDBY
after approx. 5 minutes.
Notes:
AUTO POWER OFF is canceled if the SR5400 is
set to a source other than TV.
The function reactivates when TV is selected
again.
Some TV broadcasts may cause the TV AUTO
FUNCTION to turn ON.
The S-Video terminal does not support TV AUTO
ON/OFF function.
ATTENUATION TO ANALOG INPUT
SIGNAL
If the selected analog audio input signal is greater
than the capable level of internal processing, the
PEAK indicator will light up on the front display.
If this happens, you should press the ATT button
on the front panel or on the remote.
ATT indicator will be illuminated when this function
is activated. The signal-input level is reduced by
about half. Attenuation will not work with the output
signal of TAPE-OUT, CD-R/MD-OUT, VCR1-OUT
and DSS/VCR2-OUT.
This function is memorized for each individual
input source.
LISTENING THROUGH HEADPHONES
This jack may be used to listen to the SR5400s
output through a pair of headphones. Be certain that
the headphones have a standard 1/4" stereo phono
plug. (Note that the speakers will automatically be
turned off when the headphone jack is in use.)
Notes:
When using headphones, the surround mode will
change to STEREO and TruSurround (TS)
headphones by SURROUND MODE selector.
The surround mode returns to the previous setting
as soon as the plug is removed from the jack.
VIDEO ON/OFF
When no video signal is connected to the SR5400
or a DVD, etc., is connected directly to your TV, the
unnecessary video circuit can be turned off by
selecting the VIDEO OFF setting.
To select video off, press the VIDEO OFF button
on the front panel.
DISPLAY MODE
You can select the display mode for the front display
of the SR5400.
To select this mode, press the DISPLAY on the
remote control.
When this button is pressed, the display mode is
switched in the following sequence.
Surround Mode Auto-display Off Display
Off Input Function Surround Mode....
In Auto display off mode, the display is off. But, if
you make a change to the unit such as input or
surround mode, the display will show that change,
then go back to off after about 3 seconds. When
changing the volume, it is not displayed.
In Display off mode, the display is off completely.
Notes:
Only the DISP indicator will be illuminated on the
front display, in display off condition
AV SURROUND RECEIVER SR5400
SELECTOR
MEMORY
TUNINGCLEAR
POWER ON/STANDBY
PHONES
ENTER
STANDBY
SELECT
DSS/VCR2
AUX
VCR1
DVD
TV
A/D6.1CH INPUTVIDEO OFF
UP
VOLUME
DOWN
MODE
MUTE
AUX INPUT
S-VIDEO VIDEO L AUDIO R
ATT
CD
CD-R
TAPE
TUNER
S-DIRECT DISPLAY
F/P
AV SURROUND RECEIVER SR5400
DOWN
MEMORY
TUNING
MODE
CLEAR
MUTE
PHONES
ENTER
S-VIDE
DSS/VCR2
AUX
VCR1
DVD
TV
CD
CD-R
TAPE
TUNER
S-DIRECT DISPLAY
A/D6.1CH INPUTVIDEO OFF
F/P
DISP MULTI AUTO TUNED ST V
OFF NIGHT PEAK ANALOG
DIGITAL
ATT
SLEEP
SURR
AUTO
DIRECT DISC 6.1 MTX 6.1 SPKR AB EQ
DIGITAL
SURROUND
PCM
L
C
R
SL S SR
LFE
AV SURROUND RECEIVER SR5400
MEMORY
TUNINGCLEAR
PHONES
ENTER
DSS/VCR2
AUX
VCR1
DVD
TV
CD
CD-R
TAPE
S-DIRECT
A/D6.1CH INPUTVIDEO OFF
F/P
DISP MULTI AUTO TUNED ST V
OFF NIGHT PEAK ANALOG
DIGITAL
ATT
SLEEP
SURR
AUTO
DIRECT DISC 6.1 MTX 6.1 SPKR AB EQ
DIGITAL
SURROUND
PCM
L
C
R
SL S SR
LFE
SELECTING ANALOG AUDIO INPUT
OR DIGITAL AUDIO INPUT
If you have already assigned the digital inputs, you
can temporarily select the audio input mode for
each input source with the A/D button on the remote
controller or front panel.
When this button is pressed, the input mode is
switched in the following sequence.
Digital Auto Digital Analog Digital Auto....
In Digital Auto mode, the types of signals being
input to the digital and analog input jacks for the
selected input source are detected automatically.
If no digital signal is being input, the analog input
jacks are selected automatically.
In Digital mode, input is fixed to an assigned digital
input terminal.
In analog mode, the analog input jacks are selected.
This selecting is temporary, so the result will not be
stored in memory.
If you need to change the input mode completely,
use SYSTEM SETUP in OSD menu system. (see
page 17)
ROUND RECEIVER SR5400
MEMORY
TUNING
MODE
CLEAR
PHONES
ENTER
DSS/VCR2
AUX
VCR1
DVD
TV
CD
CD-R
TAPE
TUNER
S-DIRECT DISPLAY
A/D6.1CH INPUTVIDEO OFF
F/P
DISC/DECK
PTY
ATT.
F.DIRECT
DISP./RDS
TUNE/SEARCH
MODE
TREBLE
BASS
SYSTEM REMOTE CONTROLLER
RC5400SR
+/A
/VCR
/ANT
/B
F.DIRECT
DISP./RDS
TUNE/SEARCH
MODE
TREBLE
CHANNEL/SKIP
BASS
A/D
P.SCAN
6.1CH IN
STEREO
M-CH ST
MEMO
CLEAR
DISPLAY
NIGHT
CSII EX/ES DSP
DTS
S-DIRECT
AUTO
321
654
98
0
7
T.TONE
MENU OFF
SETUP/
F.DIRECT
DISP./RDS
TUNE/SEARCH
MODE
TREBLE
CHANNEL/SKIP
BASS
A/D
P.SCAN
6.1CH IN
STEREO
M-CH ST
MEMO
CLEAR
DISPLAY
NIGHT
CSII EX/ES DSP
DTS
S-DIRECT
AUTO
321
654
98
0
7
T.TONE
MENU OFF
SETUP/
27

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Marantz-SR-5400

Zoeken resetten

  • Ik ben op zoek naar de Marantz handleiding van de Marantz SR8002. Ik kan m verder op het internet niet vinden. Wellicht heeft iemand hier deze nog ? Gesteld op 23-6-2023 om 19:07

    Reageer op deze vraag Misbruik melden
  • kan ik een draaitafel aansluiten op de marantz sr-5400 Gesteld op 27-8-2015 om 13:42

    Reageer op deze vraag Misbruik melden
    • lijkt me stug, een voorversterker. Zo'n komplete versterker heeft heeft heus wel een ingebouwde voorversterker. Ik heb het spul vd week aangesloten (volumeknop doet niets maar volume via afstand doet het wel) maar juist de platenspeler nog niet aangesloten. Ga ik wel doen in de nabije toekomst. als dat niet werkt laat ik het weten weten. Geantwoord op 5-2-2022 om 13:28

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Marantz SR-5400 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Marantz SR-5400 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,34 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info