8.6.2 Checking the automatic cut-out
• Place an obstacle in the path of the gate in both the
OPEN and CLOSE directions.
• For each direction, drive the gate into the obstacle.
The operator system must stop and reverse when
it hits the obstacle.
Caution!
The automatic cut-out must be
correctly programmed for the CLOSE
and OPEN directions to prevent
damage to persons or property.
8. Initial operation
The operator system determines the maximum required
driving power during the first two runs after setting
the end positions of the gate.
• Operate the operator system (with the gate coupled)
to drive the gate once from the CLOSED position to
the OPEN position and back to the CLOSED position
without interruption.
During this learning run, the operator system
determines the maximum push and pull forces and
the reserve power required to move the gate.
1.
After pressing the (+) button:
The gate must open and travel to the
saved OPEN end position.
2.
After pressing the (–) button:
The gate must close and travel to the
saved CLOSED end position.
3.
After pressing the hand transmitter
button: The operator system must move
the gate in either the “OPEN” or
“CLOSE” direction.
4.
After pressing the hand transmitter
button while the operator system is
running:
The operator system must stop.
5.
When the button is pressed again,
the operator system moves in the
opposite direction.
Check:
After express programming and after
making changes to the programming
menu, the following learning runs and
checks must be carried out.
8.6 Function test
8.6.1 Learning run for determining
the driving power
Test:
Advice:
The parameter settings are still saved
if the power supply is disconnected.
Only a reset causes the driving power
settings for the OPEN and CLOSE
directions to revert to the factory
settings.
Operating Instructions, Comfort 580 GB (#91636) 33
