Manual for installation and operation, Comfort 211 accu, solar GB (#76810) 37
9. Extended operator functions
9.1 General notes on extended
operator functions
Caution!
Important factory default settings can
be changed using the extended
functions.
All the parameters must be set correctly
to avoid damage to persons or
property.
Additional functions can be programmed for the
operator system using the extended functions.
The programming facility is divided into three areas:
Area 1: Levels
The adjustable functions have been grouped in
8 levels according to the type of function.
Each level can have up to 8 menus.
The + and - buttons are used to scroll through the
selections within the levels.
Levels that are not used are displayed but cannot be
opened.
Levels-Exit switches from programming to operating
mode.
Area 2: Menu
Each menu sets one parameter.
The + and - buttons are used to scroll through the
settings within the menus.
Menus that are not in use are skipped over and are
not displayed.
You can return to the first level via Menu-Exit.
Area 3: Parameters
Each function has a maximum of 16 settings.
The + and - buttons are used to scroll through the
settings for the adjustable parameters.
Parameters that cannot be adjusted are skipped over
and not displayed.
It is not possible to overshoot by pressing the
+ and - buttons.
Reference:
- All the available levels and menus are
described in the overview of the
programmable functions (Section 9.3).
- The messages are explained in
Section 10.
End Programming
The programming session can be ended in two ways:
1. Via Levels-Exit, by pressing the P button. The
controls then switch to operating mode.
2. By pressing the P button for longer than 5 seconds
at any time and from any area.
The controls then switch to operating mode.
If a parameter had been changed, it will be saved in
the process.
When the programming session ends, all the LEDs light
up and then go out one after the other, in sequence
from 8 to 1.
If no buttons are pressed within 120 seconds while in
programming mode, the controls revert to operating
mode.
A corresponding message is displayed.
