English Page 18
O
9
Garage door operator for sectional doors:
• Screw the lintel joining plate (A) with boom to the lintel or ceiling, so that the
upper lamella of the door lies approx. 10 mm below the horizontal downward boom edge -
measured from the highest point of the opening course (see pictures 8.1 and 11).
(The fixing material for the lintel joining plate is not included in the supply package).
• Put the motor unit on a trestle or another suitable object until it is fixed later
on to the ceiling.
• Join two door link brackets (B) to the door connector (C) and screw them with 4 screws to
the upper door lamella (see picture 8.1). Drill bit ø 5mm.
• If necessary, the motor unit can be installed 200 mm off-centre.
• For wooden sectional doors please use wood-screws ø 5x35mm. Drill bit ø: 3 mm.
• Screw two self-tapping screws (D) into the door connector until the points of the screws are
situated in front of the lamella.
• Insert door link (E) with bolt (G) into the carriage (F) and fix it with 2 screws.
• Connect door link to door link bracket (see picture 8.1).
Remove the door locks or put them out of operation.
Attention:
For big and heavy sectional doors please use additionally door connector attachment
Spezial 111, Art.-No. 47 574 (see picture 8.2).
(This is not part of the supply package)
O
8
Garage door operator for retractable up-and-over door:
Adapter arm Special 102, Art.-No. 564 865 and photocell Special 606, Art.-No. 47 816 are
required. (These are not part of the supply package Comfort 200).
Before installing the motor unit, put the door locks out of operation or
remove them.
• Screw the lintel joining plate (A) with boom to the top door frame, lintel or ceiling, so that
the upper door edge lies approx. 10 mm below the horizontal downward boom edge -
measured from the highest point of the opening course (see pictures 9 and 11).
(The fixing material for the lintel joining plate is not included in the supply package).
• Put the motor unit on a trestle or another suitable object until it is fixed later on to the
ceiling.
Fitting the adapter arm:
• Screw the support bracket (B) to the upper door edge using 6 self-tapping screws
(Drill bit ø: 5 mm).
• Centre of support bracket equals to the centre of boom.
• Put adapter arm (C) into support bracket (B) and screw it to the door cross strut (E) using
two angle plates (D).
(Drill bit ø: 5 mm) in the door cross strut (4 x)
(Drill bit ø: 7 mm) in the adapter arm (2 x)
