On completing the installation and having checked the function, the door must be locked.
If the emergency release is required, the door must first be unlocked.
After having used the emergency release, make a test run to make sure that the motor operates
the door again.
The bolt (picture 1a / position B), the metal lever (picture 1 b / position B) and the dividing bolt
(picture 1 d/ position B) in the carriage must be removed to their rear operating position.
The red disengagement pin (picture 1C/ Position G) of the flat carriage has to be pushed
back manually in direction of the arrow.
The symbols (pictograms) on the downward side of the carriage indicate the actual state
according to illustration:
Door is separated from operator.
• The front edge of the movable slide bar (B) is above the arrow symbol 'lock open'.
Door is connected to operator or will be reconnected automatically after next door
travel.
• The front edge of the movable slide bar (B) is above arrow symbol 'lock closed'.
Attention:
Check the function of the emergency release regularly.
Page 11
GB
Shortening the Bowden Cable: (If necessary)
With the door open, establish the exact length.
Remove end sleeve from the bowden cable mantle, pull the wire cable far enough back to
allow the outer mantle to be cut through at the appropriate point. Replace the end sleeve.
Push the screw nipple onto the wire cable and shorten the remaining length to approx. 50 mm.
Tip:
Before cutting through the wire cable, wrap with insulation tape to prevent the cable
from splicing.
O
6
O
7
