691397
9
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
9 ENGLISH
Replacing the oil
Fig.9:
1. Intake shut-off valve 2. Drain plug
1. Open the intake shut-off valve.
2. Operate the pump for 1 or 2 minutes to warm up the
oil.
3. Turn the pump off.
4. Remove the drain plug and drain the oil.
5. Refer to “Adding oil” and add new oil.
Dispose of the old oil in accordance with local
regulations.
NOTE: It is recommended to change the oil after
20 hours of usage to protect pump components from
contaminants pulled into the pump.
When vacuuming on old refrigeration systems, change
the oil after every usage.
Vacuum pump oil:
The condition and type of oil used in any high performance
vacuum pump are extremely important in determining
the ultimate attainable vacuum. It is recommended to
use the High Performance Vacuum Pump Oil, which is
specically blended to maintain maximum viscosity at
normal temperatures and to improve start up under cold
weather.
Cleaning the pump
1. When the oil is extremely dirty, replace the oil and
then operate the pump for 3 to 5 minutes.
2. Drain the oil and add new oil.
If the drained oil is still dirty, repeat this cleaning
process two or three times.
Troubleshooting
Condition Possible Cause Solution
The pump will not start. 1. The battery is not set properly.
2. The ambient temperature is too low.
3. Poor wiring connection.
4. The pump is locked.
5. Motor failure.
1. Set the battery properly.
2. Warm up the pump in doors.
3. Repair.
4. Repair.
5. Repair.
The pump will not enough vacuum. 1. Leaking from the system.
2. Insufcient oil.
3. Dirty oil.
4. Pump parts are worn out.
5. Damaged ttings, gaskets and seal.
6. Motor failure.
1. Repair the system.
2. Rell or change oil.
3. Clean reservoir and change oil.
4. Repair.
5. Repair.
6. Repair.
Oil leakage. 1. Damaged gaskets and shaft seals.
2. Damaged O-ring of oil drain plug.
3. Oil drain plug is loose.
1. Repair.
2. Replace O-ring.
3. Tighten Oil drain plug.
Abnormal noise. 1. Motor failure.
2. Bearing failure.
3. Loose bolts.
4. Pump failure.
5. Air is sucked.
1. Repair.
2. Repair.
3. Tighten bolts.
4. Repair.
5. Tighten caps and connections.
Replace gaskets and O-rings.
Replace ttings or re-seal them.
Remark: If these procedures do not solve the problem, contact with your nearest Makita authorized distributor or send
your pump to our service center.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Makita DVP180 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Makita DVP180 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens als bijlage per email.

De handleiding is 6,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info