494083
27
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
In case of difficulty
24
Others
If operation freezes, the screen goes black or the unit should otherwise not function properly,
try turning the power off then back on. Alternatively, try the following methods in the order
listed until the unit returns to normal playback mode.
1) Turn the car’s ignition OFF and back ON again.
2) Press the RESET button on the face of the unit
This guide will help you isolate the problem if the unit is at fault. Otherwise, make sure the
rest of your system is properly connected or consult a professional mobile video installer.
Unit does not
operate.
Fuse is blown.
Monitor’s power is not turn on.
Condensation
Replace with a fuse of the specified capacity.
Turn on the m onitor’s power
Wait a while(about 1 hour) for the condensation
to dry.
Operation is
unstable.
Remote control unit’s
battery is worn.
Replace the remote control unit’s battery with
new one.
Remote control sensor or
transmitter is dirty.
Clean the sensor or transmitter.
No picture is
produced.
Monitors mode is not
switched to the mode you
want to see.
Switch to the mode you want to see.
Playback does
not start.
Disc is loaded upside-down.
Check the disc and load it with the labeled side
facing upward.
Disc is dirty.
Clean the disc.
A disc not able to playback
with this unit is loaded.
Check if the disc is able to be played back.
Parental lock is set.
Cancel the parental lock or change the rating
level.
Picture is
unclear or noisy
Disc is being fast-forwarded
or fast-reversed.
The picture may be slightly disturbed, but this
is normal.
Vehicle’s battery power is
weak.
Check the battery power and wiring.
The unit may malfunction if the battery power is
under 10.8 volts with a load applied.
Monitors fluorescent tube is
worn.
Replace the monitor’s fluorescent tube.
Image stops
sometimes.
Disc is scratched.
Replaced with a non-scratched disc.
No disc
No disc is loaded.
Load a disc.
Disc is dirty.
Clean the disc.
Not valid
Remote control operation
is not possible.
For some discs or playing modes, certain
operations are not possible. This not a
malfunction.
VIDEO SIGNAL
SYSTEM IS NOT
CORRECT
PAL( or NTSC) disc is loaded.
Change the TV TYPE of the unit(see SET UP).
Symptom Cause Remedy
No sound Select the wrong Audio Out
According to the connection, set ANALOG for
using audio cable, set SPDIF/RAM/PCM for
using coaxial cable. See page 7,8 and 19.
27

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Macrom M-DVD9900 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Macrom M-DVD9900 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info