166337
7
Verklein
Vergroot
Pagina terug
1/26
Pagina verder
7
CONTROLS AND INDICATORS
1 • RCAINPUT CONNECTORS: connect the pre-output leads of the head
unit to the input connectors.
2 • INPUT MODE SELECTOR: allows to select the amplifier’s
configuration as follows:
a) STEREO “ST” when the amplifier is used as a two-channel stereo
system (right + left);
b) MONO (L mono) when the amplifier is driven by one input signal “Left”
and outputs are mono-bridged.
NOTE: in this configuration, no signal is present at the “Right” pre-output
RCAoutput connection;
c) MIX “L+R”: when the amplifier is designed to drive one or more subwoofers according to the
1-, 2- or 3-channel configurations. Thus, the inputs signals will be blended into one signal.
NOTE: anyway, the signals present at the Pre-output outputs will always be stereo.
3 • INPUT GAIN ADJUSTMENT CONTROL: input sensitivity ranges from 200 mV to 2V.
Set the mid position for all MACROM units.
In case the amplifier is to be connected to a head unit that is not of MACROM make but is
fitted with preamplified RCAoutputs, proceed as follows:
a) set the volume control of your head unit to 3/4 of maximum ouput
level;
b) set the input gain control to the point where the maximum sound
level with no distortion is obtained.
4 • LOW-PASS SELECTOR SWITCH: it allows to select the
amplifiers output mode by activating the Low-Pass crossover.
a) Flat: the amplifier reproduces the whole range of frequencies from 20 Hz
to 20kHz
b) Low: the amplifier reproduces low frequencies only.
5 • LOW-PASS FREQUENCY ADJUSTMENT: allows the continuous
adjustment of the low-pass frequency between 30 and 600 Hz, to
determine the end point of the audio range present at the amplifier’s
outputs and at the Pre-output outputs should the low-pass filter be selected.
6 • HI-PASS FREQUENCYADJUSTMENT: allows the continuous adjustment of the high-pass
frequency between 30 and 600 Hz, to determine the starting
value of the audio range present at the Pre-Output outputs.
7 • PRE-OUTPUT SELECTOR SWITCH: allows to select the
Pre-output output mode as follows:
a) FLAT: a signal having the same form and amplitude as the
input signal is present at the Pre-output outputs;
b) LOW: a low-pass signal is present at the Pre-output outputs
in order to drive an additional amplifier. Frequencies can be
adjusted by means of the LOW-PASS FREQUENCY “5”
control;
c) HIGH: a high-pass signal is present at the Pre-output outputs in order to drive an additional
amplifier. Frequencies can be adjusted by means of the HIGH-PASS FREQUENCY “6” control.
Flat Low
Flat Low
20Hz 20kHz
20Hz 30>600Hz
L(mono) ST L+R
L(mono) ST L+R
L(mono) ST L+R
20Hz 20kHz
20Hz 30>600Hz
Flat Low High
Flat Low High
Flat Low High
30>600Hz 20kHz
O/M 42.29 26/06/02 10:19 Page 7
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Macrom 42 29 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Macrom 42 29 in de taal/talen: Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 0,23 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info