Handleiding MTD Zero Turn Serie Z-Force SZ (pagina 14 van 18) (Engels)

629101

Verklein

Vergroot

Pagina terug

1/18

Pagina verder

Operating Manual English

Note

Be particularly careful when

reversing. Never change the

direction of travel without first

bringing the unit to a standstill.

 Start the engine as indicated.

 Release the parking brake. Press

down fully the brake pedal, and

release it.

 Slowly engage the drive pedal

until you have reached the speed

you want.

Note

The forwards and reverse accele-

rator pedal must not be used if the

brake pedal is depressed. This may

damage the gears.

Stopping the unit

 Release the accelerator.

 Depress brake pedal until the

unit stops.

Mowing

Note

– In normal mowing mode

(see Operation,

ignition lock): Before reversing

the machine, switch off and raise

the cutter deck.

– In reverse mowing mode

(see Operation,

ignition lock): Exercise extreme

caution when reverse mowing

and do not activate unless

absolutely necessary.

– Do not change direction when the

appliance is coasting or driving.

 Start the engine as indicated.

 To ensure adequate power

output, move the throttle to .

 Switch on the cutter deck.



Lower the cutter deck.

 Release the parking brake.

Press down fully the brake pedal,

and release it.

 Slowly depress the forward drive

pedal for forward direction of

travel and speed. The appliance

starts moving.

Information on PTO switch

When the safety lock system has

automatically switched OFF the

appliance (e.g. when reversing with

activated cutters), first switch ON

and then OFF the PTO switch to

release the lock on the clutch.

General information

When adjusting the cutting height

and driving speed, ensure that the

machine is not overloaded.

Depending on the length, type, and

dampness of the grass it may

become necessary to adjust the

cutting height and appliance speed

for the optimum grass catcher

performance.

If blockages occur, reduce the

driving speed and increase the

cutting height.

The best way to mow

Cut the first two rounds so the cut

grass is thrown out sideways into

the middle.

 Never allow the grass to grow too

long

 Never cut the grass too low.

 Drive in a straight line.

 Never mow at high speed,

particularly when a mulching kit

or grass catcher is installed.

Mulching

Various appliances can also mulch

when fitted with the corresponding

accessories. Ask your specialised

dealer for details.

Note

This appliance is designed to mow

lawns. Do not mow scrub, weeds,

or overlong grass.

Switching off the machine

 Stopping the unit:

Release the accelerator press

brake pedal until the appliance is

stationary.

 Switching off the cutter deck.

 Set the throttle lever into the

middle position.

 Raise the cutters to the top.

 After 20 seconds set ignition key

to .

 Engage the locking brake before

leaving the appliance.

 Close fuel tap.

 Remove the ignition key.

Pushing the appliance

Fig. 13

Push the appliance only when the

engine is switched OFF.

 Release the parking brake.

 Release both gears:

Pull out both gear

release levers and

press to the right.

Before starting the engine move

back the two gear release levers to

their home positions.

Note

Never tow the appliance.

This can cause serious damage to

the gears.

Tips on lawn care

Mowing

A lawn is made up of various

different types of grass. If you mow

your lawn frequently, those types of

grass which form strong roots and

a firm turf surface will grow better. If

you seldom cut the grass, you will

enhance the development of high-

growing types of grass and other

weeds, such as clover, daisies ...).

The normal height of a lawn is

approx. 4–5 cm. Only

of the total

height should be mown; therefore

cut 7–8 cm long grass to normal

height.

Preferably do not cut the lawn

shorter than 4 cm, otherwise the

sward will be damaged in a dry

period. If the grass has grown

particularly high (for example,

during a holiday period), cut it back

to its normal height in several

stages.

Mulching using the accessories

(optional)

During mowing the grass is cut into

small pieces (approx. 1 cm) and is

left on the ground. A lot of the

nutrients in the cut grass are

retained for the benefit of the lawn.

Please note the following:

 Do not mow wet grass.

 Never mow more than max. 2 cm

of the total grass length.

 Drive slowly.

 Use maximum engine speed

 Clean the mower cover regularly.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

MTD Zero Turn Serie Z-Force SZ Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van MTD Zero Turn Serie Z-Force SZ

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info