629099
46
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
46
Start the engine and allow it to run for a short
period. Stop the engine.
Recheck the coolant level in the overflow
reservoir and refill as needed. Reinstall the
reservoir cap.
INSPECTION OF COOLING SYSTEM HOSES
Check the cooling system hoses and fan belt for
any cracks or deterioration after every 100 hours of
operation. Check for loose hose connections.
Replace any damaged hoses and tighten any loose
connections. Replace a worn or damaged fan belt.
CHANGING THE ENGINE COOLANT
The engine coolant should be drained and replaced
with new coolant solution yearly.
The dry capacity of the cooling system is
approximately 5.2 Liter. Dilute the antifreeze with
water at a 1:1 ratio to mix the coolant solution
(50 % antifreeze : 50 % water).
Change the engine coolant as follows:
Drain the coolant when the engine is cold.
Place the tractor on a level surface and raise the
tractor hood.
Slide the overflow reservoir upward and off the res-
ervoir bracket to access the radiator drain plug.
Locate the radiator drain plug in the lower
right
rear corner of the radiator. See Figure 56.
Figure 56
Place a suitable container beneath the drain
plug and remove the cap from the overflow
reservoir.
Turn the drain plug counterclockwise to re-
move. Allow as much of the old coolant as pos-
sible to drain from the system.
Coolant is a toxic substance. Dispose of in
an environmentally safe manner. Contact
your area EPA office for proper disposal
methods and recycling center locations.
Reinstall the drain plug and turn clockwise until
fully tightened.
Turn the radiator cap counterclockwise to the
first stop, then push downward on the cap and
turn counterclockwise to remove. Refer to
Figure 50.
In stages, SLOWLY pour the coolant solution
into the filler neck, allowing as much air as
possible to escape through the neck. Fill to the
overflow flange of the filler neck.
Wait a few minutes to allow air to escape
through the filler neck and refill as needed, then
reinstall the radiator cap.
Fill the overflow reservoir to the "FULL" mark.
Start the engine and allow it to run for a short
period. Stop the engine.
Recheck the coolant level in the overflow
reservoir and refill as needed. Reinstall the
reservoir cap.
CHANGING THE AIR CLEANER
Check the air cleaner daily or before starting the
engine. Check for loose or damaged components
and check the condition of the filter element.
Remove any buildup of dirt and debris in the air
cleaner housing.
Replace the paper air cleaner element after every
300 hours of operation. More often if operating the
tractor under extremely dusty conditions.
Check and replace the air cleaner element as follows:
Unlock the clamps to remove the air cleaner
housing cover. See Figure 57.
Figure 57
RESERVOIR
BRACKET
RADIATOR
DRAIN PLUG
COVER
COVER
CLAMP
Pull Outward
to Unlock
46

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw MTD CubCadet serie 7000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van MTD CubCadet serie 7000 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,08 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van MTD CubCadet serie 7000

MTD CubCadet serie 7000 Gebruiksaanwijzing - Deutsch - 55 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info