PELLET STOVES Chapter 3
INSTALLATION AND USE MANUAL
page 25
Installation and assembly Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
E
F
3.3. CONNECTIONS OF HOT AIR DUCTS FOR
SUITE/CLUB/MUSA/NIMA AND TOBA COMFORT
AIR MODEL
Once the stove is in position, you can begin installation of the hot air
ducts.
Comfort Air stoves are provided with an air deflector E as standard.
This means that the rear flange for hot air outlet is connected to this
deflector, which allows the hot air to be directed to the right and left of
the room, in case the channelling of hot air is not desired.
If you wish to channel the hot air, the deflector E must be removed.
Connect the soundproofed connection F (optional) that makes the
output from square to round, and then make the various connections
with appropriate MCZ pipes and connections to divert the flow in more
hot air diffusers (120x120 mm nozzle). These ducts may also be walled
up. (SEE OPTIONALS)
The air outlet pipe can reach very high temperatures,
up to 200°C: it is therefore necessary to insulate it
properly with suitable materials, in those points
where it may come into contact with flammable
surfaces or that are affected by the temperature (e.g.
discolouration of paint, ducts for electric cables,
plasterboard, etc.); it is also necessary to protect
people and animals from voluntary or accidental
contact. In any case comply with the regulations and
laws in force in the region where the product is
installed.
It is advisable to provide insulation along the entire
route of the pipe to decrease dispersion and increase
the heat energy in the environment.
INSULATION
HOT AIR OUTLET
PIPE
WALL CROSSED
STOVE
