PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 24
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
PLEASE NOTE:
Icons 11, 12, 13, and 14 may be on in two different ways:
• COMPLETELY LIT (ICON COMPLETELY BLACK)
• ONLY BORDER OF ICON LIT
When the icons are completely lit it means that work is being
carried out in this function.
Example: if the symbol of the fan is completely on, it means you
are changing the hot air fan speed via button no.5.
If only the borders of the icons are lit it means that the function is
active but cannot be modified except by entering the corresponding
item from the menu. When you enter the corresponding menu, the icon
comes on completely (see above)
Example: if only the border of the icon for the fan is on, it will not
be possible to modify the fan speed by pressing button no.5
but the function is active because the fan is operating (if the
stove is on). In order to change the fan speed, it is
necessary to access the menu that allows this adjustment
and causes the icon to light up completely.
4.4.2. General characteristics of the LCD remote control
The stoves which are equipped with the ACTIVE SYSTEM combustion
control device are controlled mainly by a remote control or in an
emergency from the small rear panel.
The LCD remote control lets you take full advantage of all the features
of the stove, adjust all operating parameters, set the timer, but most of
all to continuously monitor the room temperature so as to suitable
control the stove's operation.
In fact, the temperature sensor is built right into the remote control.
This allows more precise measurement of the temperature in the room
to be heated wherever the user wants, and without the inconvenience
and limitations of wired thermostats.
The remote control has back-lighting which is activated by simply
pressing a key.
Keep the remote control away from direct heat and
water.
It is advisable to keep it out of the reach of children.
The remote control should always be kept near the
stove (within a radius of 5 m) so that correct room
temperature values are transmitted. If the stove does
not receive any input from the remote control for at
least three hours, it will start emitting periodic
acoustic signals to inform the user that the remote
control is too far away or that the batteries are dead.
The display of the emergency panel will show the
alarm A10. In this alarm condition, the stove will
continue working. To eliminate the alarm, just move
the remote control nearer to restore normal operating
conditions.
Position of the room temperature probe
