T
U
59
18-CLEANING
Technical Dept. - All rights reserved - Reproduction is prohibited
ATTENTION!
All the cleaning operations of all parts must be performed with the product completely cold and the plug
disconnected.
Disconnect the product from the 230V power supply before performing any maintenance operation.
The product requires little maintenance if used with certied good quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Before each lighting
Clean and empty any ash or deposits from ash pan “U” and brazier “T” that might obstruct the air ow holes, paying attention to any
hot ashes. If the pellets in the hopper run out, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier
before each start-up. You may only use a vacuum cleaner to remove ash when it is completely cold. In this case, use a suitable
vacuum cleaner to remove small sized particles. The quality of the pellets used and user experience will determine the cleaning frequency
required. However, it is recommended not to exceed 2 or 3 days.
EXAMPLE OF A CLEAN BRAZIER EXAMPLE OF A DIRTY BRAZIER
