812445
50
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
50
40-ALARMS
ALARM SIGNALLING
If an operating anomaly occurs the stove starts switching o due to the alarm.
The following table describes the possible alarms indicated by the stove, associated to the respective code that appears on the emergency
panel and helpful tips to solve the problem.
MESSAGE ON DISPLAY TYPE OF PROBLEM SOLUTION
A01
FAILED IGNITION
The ame does not ignite Check the level of pellets in the hopper.
Check that the brazier is correctly positioned in its seat
and has no deposits or unburnt material.
Make sure the glow plug warms up.
Carefully empty and clean the brazier before restarting.
A02
NO FLAME
The re goes out abnormally Check the level of pellets in the hopper.
Check that the brazier rests correctly in its seat and has no
visible deposits of unburnt pellets.
A03
PELLET SAFETY
The temperature of the pellet hopper
exceeds the required safety threshold.
The structure overheats due to reduced
heat dissipation.
The structure is too hot because the product has been
used for too long at the maximum power or there is poor
ventilation. When the stove is cold enough, press the
button for at least 3" to reset the alarm. Once the alarm is
cleared, the product can be switched on normally.
A04
SMOKE OVERTEMPERA
TURE
The temperature of the exhaust smoke has
exceeded certain preset safety limits.
The stove switches o automatically. Let the stove cool
down for a few minutes and then switch it on again.
Check the smoke expulsion and verify the type of pellets
used according to the instructions found in Chap. 2 of this
manual.
A05
OBSTRUCTION
Flue clogged - wind. Check the smoke duct and make sure the door is closed.
The smoke extractor fails to guarantee
sucient primary air, required for correct
combustion.
Draught diculties or clogged brazier.
Check whether the brazier is clogged and clean it, if
necessary.
Check, and if necessary clean, the smoke duct and the air
inlet.
A08
FUMES MOTOR FAULT
Abnormal operation of smoke fan Check cleanliness of the smoke fan compartment and
check whether dirt is blocking it. If this is not enough, the
smoke fan is faulty. Contact an authorised service centre
to have it replaced.
A09
THERMOCOUPLE FAULT
The smoke probe is faulty and does not
detect the exhaust smoke temperature
properly.
Contact an authorised service centre to have the
component replaced.
A11
FEED SCREW FAULT
Pellet supply fault Contact an authorised service centre to have the
component replaced.
50

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw MCZ EGO AIR 8 M3 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van MCZ EGO AIR 8 M3 in de taal/talen: Engels als bijlage per email.

De handleiding is 10.82 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van MCZ EGO AIR 8 M3

MCZ EGO AIR 8 M3 Gebruiksaanwijzing - Nederlands - 72 pagina's

MCZ EGO AIR 8 M3 Installatiehandleiding - Nederlands - 56 pagina's

MCZ EGO AIR 8 M3 Gebruiksaanwijzing - Deutsch - 72 pagina's

MCZ EGO AIR 8 M3 Installatiehandleiding - Deutsch - 56 pagina's

MCZ EGO AIR 8 M3 Installatiehandleiding - English - 56 pagina's

MCZ EGO AIR 8 M3 Gebruiksaanwijzing - Français - 72 pagina's

MCZ EGO AIR 8 M3 Installatiehandleiding - Français - 60 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info