PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL
page 43
Operation Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited
6. EMERGENCY PANEL
At the right rear of the stove, there is an emergency panel. It was
designed to diagnose any operating anomalies. It is also used to control
the stove if the remote control is not working.
KEY
A. Three figure display which indicates a series of information
about the stove, as well as the identification code for any
operating anomaly.
B. GREEN
LED to indicate:
OFF = Stove off
FLASHING = Stove in lighting phase
ON STEADY = Stove on
C. RED
LED to indicate:
OFF = Stove on
FLASHING SLOWLY = Stove shutting down
FLASHING RAPIDLY = Stove in alarm status
(accompanied for 10 minutes by a beep)
ON STEADY = Stove off
D. Three-position selector for function
OFF = Stove shut off manually in absence of remote
control
REMOTE = Stove can be controlled only by remote
control
ON = Stove turned on manually in absence of remote
control
E. Three-position selector for selection of power
MIN = Selector to run the stove at minimum power with
no remote control and with selector 4 in ON position
MED = Selector to run the stove at medium power with
no remote control and with selector
in ON position
MAX = Selector to run the stove at maximum power with
no remote control and with selector
in ON position
F. Push button for diagnostics of stove operating status
G. button to connect the stove to a new remote control (by means
of a procedure explained below)
TO OPERATE THE STOVE WITH THE REMOTE
CONTROL, SELECTOR "D" MUST BE PLACED
ON “REMOTE”
