17
3-INSTALLATION AND ASSEMBLY
FASTENING TO THE BASE OF THE INSERT
It is mandatory to anchor the product to a support as the authorised technician can remove the combustion chamber from its seat by
means of two extendable guides while performing the annual maintenance.
Fasten the insert as follows:
• Measure the distance (A) from the edge of the frame to the outer edge of the support for it to be adequately set back into place.
A= 540 mm (measurement from the edge of the frame to the outer edge of the support).
A1= 537 mm (measurement from the outer edge of the wall to the outer edge of the support).
A2= 3 mm (measurement from the outer edge of the wall to the edge of the frame).
• Remove the compensation frame C (see the relative paragraph).
• Loosen the lower screws (B) under the frame.
• Then remove the machine and separate it from its support (D).
• Set the support (D) away from the wall at the previously measured distance (A1) see gure.
• Fasten the support (D) to the base (E) with the screws supplied, making sure that the support anchor surface (D) and the wall are
perpendicular.
• Set the machine back on the support (D), insert the screws (B) again, making sure the machine and the support are well secured in
order to guarantee product operation.
It is very important to make sure the positioning measurements of the product base have been respected and the support
anchor surface and the wall are perpendicular. Also make sure that the screws secure the machine to the support.
Technical Dept. - All rights reserved - Reproduction is prohibited
