10
Maintenance and cleaning
By respecting and adhering to the following simple instructions , the beauty of your oven will last in the time: NEVER
USE scouring pads or abrasive sponges, never use corrosive or abrasive cleaning products.
� Cleaning of the interior of the oven (st/steel Never use abrasive or corrosive cleaning products . It is enough
to clean with a weat cloth , if it is very dirthy add to the warm water some neutral soap , finally dry with a dry
cloth.
� Cleaning of the interior of the oven (enamel finish) Never use abrasive or corrosive cleaning products . It is
enough to clean with a weat cloth , if it is very dirthy add to the warm water some neutral soap , finally try
with a dry cloth. In the case of difficult dirty plese use detergent for oven when oven is cold. If you are not
able to remove some particular marks, preheating the oven with the fan forced function for a maximum of 50
minutes, switch off the oven and repeat the cleaning
� Cleaning of the accessories after the use is better to put the accessories in the dishwasher (not the pizza stone
plate) or dip in the water with detergent for dishes . Use a normal sponge not abrasive for particular resistant
dirth.
� Cleaning of the pizza stone use only warm water for resistant dirt use a plastic scraper or a drop of neutral
detergent in warm water. Rince with care and well dry before to use it again
� Cleaning supports for accessories
� Remove these supports. To clean use washing up liquid and a washing up sponge. To remove resistant stains
and crusts use an abrasive sponge. After cleaning replace the supports.
� Light cover to be cleaned with a weat cloth and some drops of neutral detergent.
What to do in the event of a fault?
Before calling in a specialised service engineer read the following precautions and check the appliance:
The oven does not work:
� Check the mains electricity supply has not been cut off
Only call in specialised service engineers to repair faults. Any appliance that is not repaired correctly may create
hazardous conditions for the user.
Replacing the oven seal
It is important to control the wear and tear of the oven seal to avoid escape of heat from the oven and therefore also
waste of energy. Remove the seal turning right and left the clip fasteners positionet on the corners and on the top and
bottom of the cube.
Replacing the oven light bulb
Caution:
The oven is supplied with two alogen lamps of 40 W each.
If you need to change them first disconnect the oven. Put a dry cloth on the base of the cabinet.
Remove the light cover pushing and pull it, and replace the oven lamp.
INSTALLATION
� This built-in oven can be installed under a bench BUT NOT UNDER A HOB
. It can be installed in a column
kitchen unit. The measurements for installation in kitchen units are given in the below diagram.
� The kitchen unit must be fabricated in heat resistant materials. The oven must be aligned in the centre of the
unit and secured in position utilizing the screws and bushing provided with the appliance.
