28
L
Fig. 8.1
8 - GAS SECTION
Cat: II 2L 3B/P
GAS CONNECTION
The connection must be executed by a
qualified tecnician according to the
relevant standards.
The appliance is predisposed and
calibrated to operate with the gas
indicated on the specifications plate.
Ensure that the room in which the cook-
er is to be installed is adequately venti-
lated, in compliance with applicable reg-
ulations.
Connection to the gas supply pipe or
gas cylinder must be made in accor-
dance with the requirements of the
applicable regulations.
The gas supply is connected at the rear
of the cooker (fig. 8.1) to the R or L ter-
minal of the gas inlet pipe; the connec-
tion pipe must not cross the rear of the
appliance.
The terminal not used must be closed
off with the plug T and gasket.
Before installation, make sure that
the local distribution conditions
(type of gas and its pressure) and
the adjustment of this appliance are
compatible. The appliance adjust-
ment conditions are given on the
plate or the label.
The walls adjacent to the cooker
must be of material resistant to heat.
R
T
