195
4. Press
ENT and use ↑ ↓, ← → to input the desired name for the temp
sensor. Press
ENT. Press EXIT repeatedly to get back to the main
display.
To select Temp Type:
1. Press MENU|MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight BUS SETUP and press ENT, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired temp sensor and press
ENT. The Device
Configuration menu will appear.
4. Highlight
TEMP TYPE and press ENT. The following list of Temp Types
will appear: Water, Outside, Inside, Engine Room, Cabin, Live Well,
Bait Well, Refigeration, Heating System and Unknown.
5. Highlight the desired Temp Type and press
ENT. The following
confirmation message will appear: Are you sure you wish to change this
device's configuration?
6. Highlight
YES and press ENT. Press EXIT repeatedly to get back to the
main display.
Advanced Options menu
The Temp sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to resolve
certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support the
display of fewer electronic probes than your GPS or sonar/GPS unit. If
you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to a
network with similar display units and/or a series of electronic probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-35
Temp Sensor's settings to factory defaults. If, for example, you execute
the Restore Defaults command from your Water Temp's Advanced
Options menu, only the settings for the Water Temp will be reset to
factory defaults. Other temps on the network will not be affected.
