15
9. The Recalibration (The Recal?) menu will appear with two options:
Yes and No. Select
YES and press MENU.
NOTE:
If you do not have the fuel remaining source set to Eng/FFlow, the
recalibration message will not appear.
10. The Filled Quantity window will appear. Use the
UP and DOWN
keys to input the amount of fuel you added to the tank and press
MENU.
11. Repeat these steps for each fuel flow you want to calibrate.
Reset Calibration
The Reset Calibration command allows you to reset a fuel flow
calibration back to factory defaults.
To Reset Calibration:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU.
2. Highlight
B. DEVICES and press MENU. Select the fuel flow you want to
reset and press
MENU.
3. Select
RST CAL from the fuel flow menu and press MENU. The
following message will appear: Hit Menu to Rst the Cal.
4. Press
MENU to set calibration back to factory default settings. To
recalibrate the fuel flow, refer to the fuel flow calibration instructions
in this section.
Refill Tank (Refill T)
Since the EP-60R is not connected to the tank, its fuel information is
not automatically updated when the tank is filled up. You must use the
Refill Tank command to ensure the fuel information in the EP-60R
stays consistent with the amount of fuel actually in the tank.
To refill tank:
1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and
press
MENU. Highlight FUEL MNGR and press MENU.
2. Select
REFILL T and press MENU. If your unit is configured for more
than one tank, the Select Tank menu will appear with up to three
options. (If you are using a single tank configuration, you will not see
the Select Tank menu.)
3. Select the desired tank and press
MENU. The following message will
appear:
Hit Menu if Tank filled up. Press MENU and you will be taken
you back to the main display.
Partial Fill (Part Fill)
Since the EP-60R is not connected to the tank, its fuel information is
not automatically updated when fuel is added to the tank. When you
