Using the Alarms
Your Logitech Pure-Fi Anytime™ includes two separate alarms.
Alarm State
To enable an alarm: press alarm 1 ( ) or alarm 2 ( ). This will also show you the alarm time.
To disable an alarm: press alarm 1 ( ) or alarm 2 ( ).
Note: If an alarm is enabled, the alarm indicator for that alarm will be visible on the display.
Alarm Settings
To set the alarm settings:
1. Press and hold alarm 1 ( ) or alarm 2 ( ) for 1 second.
2. Alarm time: Press the |7 8| buttons to change the time.
3. Alarm source: Press Source ( ) to select the alarm source. Options are: iPod, AM, FM, and buzzer.
4. Alarm volume: Use / or the volume / buttons on the remote to select the alarm volume.
Notes
• To immediately exit from alarm set mode, press alarm 1 ( ) or alarm 2 ( ).
• If iPod is the selected alarm source, Logitech Pure-Fi Anytime
™ will launch the playlist named “Alarm 1”
(for Alarm 1) or “Alarm 2” (for Alarm 2) in shuffle mode when the alarm occurs. If no “Alarm 1” or “Alarm
2” playlist exists, Logitech Pure-Fi Anytime
™ will resume the current playlist. If there is no current playlist,
Logitech Pure-Fi Anytime
™ will randomly play music from the entire iPod library.
Using the Alarms
Setting the Clock
Snooze
Using the snooze feature will temporarily turn off an active alarm for several minutes – allowing you to get a few
more minutes of sleep. To activate the snooze feature:
• Press Snooze ( ) OR
• Wave your hand above the speaker (the motion sensor will activate snooze automatically)
Note
• To set the length of the snooze timer, hold the snooze button ( ) down until you hear a beep. Then,
press the |7 8|buttons to change the snooze length.
Resetting an Alarm
Resetting an alarm turns it off for the rest of the current day – and automatically turns it on for the following day.
To reset an alarm, do either of the following:
• Press Power ( ). This will also turn the speaker off. OR
• Press Source ( ). This will keep the speakers on and switch to the selected source.
Notes
• An alarm can only be reset if it is either active or snoozed. (Pressing either alarm button if no alarm is active
will toggle the alarm state rather than reset it.)
• An alarm will only sound for 60 minutes before automatically resetting itself.
Backup Battery
Your Logitech Pure-Fi Anytime
™ includes a backup battery to keep your Logitech Pure-Fi Anytime™ working even
during a power outage. The backup battery performs three functions while the power is out:
• It keeps the clock time correct
• It will remember your radio presets
• It will sound the alarm
The display will indicate when the battery is low or dead or not installed.
Notes
When using the backup battery:
• The alarm will always sound the buzzer, regardless of the alarm source setting.
• You cannot listen to the iPod or the radio.
• The display brightness will be at the lowest setting.
Setting the Clock
To set the current time:
1. Press and hold Time Set ( ) until you hear a beep.
2. Use the |7 8|buttons to change the time.
3. Press Time Set ( ) to accept the change.
5 6
