742180
11
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
ENG-5
Operating instructions
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected to an earthed electrical outlet, turn on the main switch located in front of the
appliance. A beep should be heard when the power is rst applied.
Operating by Manual Button
- Manual on/off switch: The power switch supplies power to all of the functions of the replace.
This switch must be in the ‘on’ position for any of the functions including the remote to work.
- Flame button: By pressing the ame effect button the unit will cycle through three ames.
- Heater button: Press once Heater button left hand heater on. Press again turns left hand heater off
and right hand heater on.
Press third time turns left and right hand heater off. There are 3 levels you can cycle through
including the off setting.
- Thermostat setting: 1-9 Step, room temperature is around 9-34 °C, room temperature is too high,
please turn the thermostat knob counter-clockwise direction. If you need to turn on the heater, you
can turn the thermostat knob clockwise direction.
Note: It is possible that if the room temperature is higher than the thermostat setting it will
not come into operation and the heater will remain off until the temperature of the room
cools.
Operating by Remote Handset
- Make sure the battery is installed properly in the remote control.
- The effective range of the remote control is up to 4 meters or 13 feet.
- Power On/Off button: The Power button will put the replace in a standby mode. This will turn off
all functions at once but will hold the settings in memory.
Except Heater function, by pressing the button again the unit will turn on at the same settings.
- Flame effect button: The re has three ame effects, by pressing the ame effect button the
unit will cycle through each effect.
- High button: Press once turns Fan on, 8s later High heat on. Press again turns heat off. 8s later fan
off.
- Low button: Press once turns Fan on, and 8s later Low heat on. Press again turns heat off. 8s later
Fan off.
To Reset the Heater
The appliance is tted with an protection system. The heater includes a protection system that shuts off the
heater if it overheats for any reason:
- Turn unit to off.
- Unplug unit wait 5 minutes.
- Plug in and turn on.
- Remote control functions
In order to protect the product not becoming too hot, there is 8s delay when turning on the heater,
also there is 8s delay when turning off the heater fan.
Receiver
Main power
switch
Flame
button
Heater
button
Thermostat
knob
11

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Livin-Flame-Zurich

Zoeken resetten

  • De elektrische inzethaard staat uit, maar schakelt zich vanzelf afwisselend in en uit. Het enige wat helpt is de stekker uit het stopcontact trekken. Waar kan dat aan liggen? Gesteld op 21-10-2023 om 18:50

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Livin Flame Zurich bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Livin Flame Zurich in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 3,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info