• Press the ‘→’ button to move the cursor to the time period setting area. Press ‘←’ or ‘→’
• to choose hour or minute, press ‘+’ or ‘-’ to set the number.
• Max 3 heating periods for a day.
• Minute will increase/decrease by 15 minutes per press.
• Press the to set the heating time for the selected day(s) and return to the week line.
• Hold for 3s or wait for 10s to save and exit the heating time period setting.
3.2.26 Press , ‘←’ and ‘→’ to check your week timer settings.
3.2.27 If heating needs to be turned off, it will be necessary to go back to the Normal Control Mode
to turn off.
Advance Mode
3.2.28 Under the daily and week timer mode, Press :
3.2.29 To turn the heater off when the heater is on during a preset heating period.
3.2.30 To turn the heater on when the heater is off in between preset heating periods.
Adaptive Start Control
3.2.31 According to room temperature and settemperature, the heater will automatically come on in
time to heat the room to the set temperature at the set time. For example, if your timer is set
to start at 18:00 and temperature is set to 23°C, the fire will come on at 17:30 to ensure the
room is 23°C at 18:00.
Window Open Detection
3.2.32 When the transmitter detects a rapid drop in room temperature, it will be judged as a
window open, the warning icon will be displayed and the heating will be turned off
automatically.
3.2.33 After the indoor temperature has risen or a manual override of the warning (by
operating remote control) has been done, the fire will return to normal working state.
Set up the communication between the remote and appliance
3.2.34 The below operations should be carried out before programming, when changing to a new
remote or in the event the appliance cannot be controlled by the remote:
• Hold the reset button on the appliance for 3 seconds (pen point may needed) until you hear 3
short beeps from the unit, release the button.
• Press the button on the remote, the programming is finished when you hear 1long beep
from the appliance.
3.2.35 Resetting the code for remote control is necessary if the appliance operates wrongly or the
remote control does not operate correctly.
• Open the back cover of the remote control.
• Press the Reset button on remote handset.
• Follow the steps 6.2.34
Resetting the Thermal Cut Out
3.2.36 The appliance is fitted with an Electronic Safety Control (E.S.). This is a safety device, which switches off
the fire if, for any reason, the appliance overheats, e.g. when covered. If the heater stops operating while the
flame effect continues working normally, this indicates that the E.S. Control is in operation. The E.S. Control can only
be re-set after the appliance has cooled down, and the appliance has been reset. Re-setting of the E.S. Control
proceeds is as follows:
3.2.37 Switch off the appliance (Manual On/Off switch) and leave it off for approximately 10-15 minutes.
3.2.38 Remove any obstruction to the fan heater outlet or fan blades etc. Make sure that the power supply is
disconnected with the plug socket outlet while doing this.
3.2.39 Switch on the appliance and the E.S. Control will be re-set.
3.2.40 Ensure that the appliance is functioning correctly. If the E.S. Control operates
again, the appliance should
be checked by a competent electrician.
