815354
3
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
13 2
NOTE: Set up as close to power source as possible. The product
should be periodically examined for potentially unsafe conditions
such as: damaged cord, plug, housing or parts, and that in the
event such damage is found, the product should not be used until
properly repaired. Never leave the blower outside in the rain or
exposed to the elements when not in use. When in use, do not
place the cord across trac areas, water or damp areas. The
blower should be placed on a stable surface and anchored per
product instructions. The power cord of the blower is equipped
with a Ground Faulty Circuit Interrupter (GFCI) plug.
1) Make sure that the blower switch is in the “OFF” position. Plug
the blower into a properly grounded 110-120V GFCI outlet.
2) If the GFCI has been tripped, press the “RESET” button to
restore power to the blower.
3) Set the power switch of the blower to “ON” to inflate. After use,
turn the power to “OFF.”
4) To disconnect, have an adult grip it tightly and pull the plug
from wall outlet.
MODEL RW-2LA
BLOWER SPECIFICATIONS: 115V (AC),
60 Hz, 4.8A, 552W
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric circuit. This product is equipped with a cord having a grounding wire with an ap-
propriate grounding plug. This plug must be plugged into an outlet that is properly installed and grounded in accordance with
all local codes and ordinances. DANGER - Improper installation of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either at blade terminal. The
wire with insulation having an outer surface that is green, with or without yellow stripes, is the Grounding wire. Check with a
Qualied electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether
The product is properly grounded. Do not modify the plug provided; if it will not t the outlet, have the proper outlet installed
by a qualied electrician. For a grounded, cord-connected product, rated less than 15 amperes and intended for use on a
nominal 110-120-volt supply circuit, these instructions should be followed. This product is for use on a nominal 110-120-
volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A. Temporary adapters should not
be used. Do not use product until a properly grounded outlet (sketch A) can be installed by a qualied electrician.
CAUTION: The blower is a high volume blower, and is capable of moving lots of air very quickly. Place the blower in
an area where it will not suck in dirt or leaves. Keep away from water and trafc. Keep children away from the blower.
Only the blower supplied should be used for ination
Safety Warnings: ELECTRICAL BLOWER
This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
TS
E
T
TE
S
E
R
GROUNDING METHODS
Grounding
pin
DANGER
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
Do not immerse the blower in water. Unplug the blower before cleaning. To clean: wipe with a damp cloth. The blower does not require
any lubrication and has no user serviceable parts. Do not attempt to service the blower. When not in use, store the blower indoors in a
dry place. Store the blower upright on a stable surface. Loosely coil the cord and place it beside the blower.
INSTRUCTIONS FOR BLOWER INSTALLATION
USE ONLY ON GFCI PROTECTED RECEPTACLES CAUTION
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH. ADULT SET-UP
AND SUPERVISION REQUIRED.
DANGER - TO PREVENT ELECTRIC SHOCK, DO NOT IMMERSE
IN WATER. WIPE CLEAN WITH DAMP CLOTH.
WARNING: Failure to follow these instructions could
result in serious injury or death.
!
WARNING
Electrocution Hazard- DO NOT USE
EXTENSION CORDS WITH THIS PRODUCT.
Cautionary statements should be read before beginning assembly.
ADULT SET-UP AND SUPERVISION REQUIRED.
Use only with Ground Fault Circuit Interrupt (GFCI) receptacle.
This blower is for residential use only. It is not intended to be used in commercial or
industrial settings.
Never insert fingers, pencils or any other object through the grill at ANY time.
Do not operate blower with a damaged cord or plug, after the appliance malfunctions
or has been dropped or damaged in any manner.
Do not operate in the presence of explosive and/or flammable fumes.
Never connect the blower to any solid - state speed control device.
To reduce the risk of fire or electric shock, do not use this blower with any solid-state
speed control device.
WARNING - Electronic hazard - Do not use extension cords with this product.
Outdoor use only.
Change the water of the pool frequently (particularly in hot weather) or when
noticeably contaminated.
Children can drown in very small amounts of water. Empty the pool when not in use.
Do not install the pool over concrete, asphalt or any other hard surface.
CAUTION: ELECTRICALLY
OPERATED PRODUCT
LISTED
E230679
Storage
23
Fold all pieces of the waterpark (i.e. Slide,
Air Inlet Tube, etc.) toward the center.
NOTE: If bottom surface is still moist, allow it to air
dry prior to folding.
Roll up the waterpark
tightly and compress the
fabric to expel all of the
remaining air.
NOTE: Do not place the
Water Spray Tubing
inside the waterpark
when rolling it up.
Repair Patch Instructions WARNING: NOT A TOY. ADULT USE ONLY.
Repair Patch. Keep away from children.
1
2
WARNING: Repair patches must be applied by an adult only. KEEP OUT OF REACH OF CHILDREN.
REPAIR PATCH INSTRUCTION
1. Deate the item, clean the area and allow to dry thoroughly.
2. Cut a portion of the patch to the size needed and round the corners. (See Fig. 1 & 2).
3. Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
4. Allow to sit for 30 minutes before re-inflating.
1
Instructions for
Bouncer Maintenance
Instructions for
Blower Maintenance
• As an outdoor product, the bouncer is subject to wear and
deterioration. Inspect for signs of fabric failure; weak or torn
surfaces must be repaired promptly.
• To keep the product clean: wipe the bouncer or blower using a dry
cloth or a cloth dampened with a neutral, non-ammable, non-
toxic cleaning and sanitizing solution or pure water.
• Product should never be stored wet. Allow to dry before rolling up.
Disposal
• Disassemble and dispose of the equipment in such a manner that no hazardous
conditions exist at the time the equipment is discarded.
• Blower should be returned to a collection center capable of
processing electrical/electronic waste.
Blower must be unplugged before servicing.
Product should be periodically examined for potentially unsafe conditions such as
damaged cord, plug, housing, or parts, and that in the even such damage is found,
the product should not be used until properly repaired. If these checks are not carried
out, the product could overturn or otherwise become a hazard.
The blower does not require any lubrication and has no user serviceable parts. Do not
attempt to service the blower.
Do not immerse the fan in water. To clean, wipe with a damp cloth.
Regularly check the intake and output openings and keep free of dirt, leaves, etc.
When not in use, store the blower indoors in a dry place.
Store the blower upright on a stable surface.
Loosely coil the cord and place it beside the blower.
When in use, do not place the cord across traffic areas, water or damp areas.
The blower is a high volume blower and is capable of moving large volumes of air
very quickly. Place the blower in an area where it will not draw in dirt or leaves.
Do not operate any fan with a damaged cord or plug. Discard fan or return to an
authorized service facility for examination and/or repair.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under furniture or appliances. Arrange cord
away from trac area and where it will not be tripped over.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Little tikes 486166 Obstacle Course Waterpark bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Little tikes 486166 Obstacle Course Waterpark in de taal/talen: Engels als bijlage per email.

De handleiding is 2.78 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info