57026
5
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
WARNING
Fire hazard due to refrigerant!
The refrigerant R 600a is environmentally friendly but flam-
mable. Escaping refrigerant may ignite.
uDo not damage the piping of the refrigeration circuit.
WARNING
Fire hazard and danger of damage!
uDo not place appliances emitting heat e.g. microwaves,
toasters etc. on the appliance!
WARNING
Blocked ventilation openings pose a risk of fire and damage!
uAlways keep the ventilation openings clear. Always ensure
that the appliance is properly ventilated!
qIn the event that the appliance is damaged, contact the
supplier immediately before connecting to the mains.
qThe floor at the site must be flat and level.
qDo not install the appliance in a location where it is exposed
to direct radiation of the sun, next to a cooker, heater and
similar.
qAlways stand the appliance backed directly to the wall using
the enclosed wall spacers (see below).
qThe appliance may be moved only when it is empty.
qDo not install the appliance without assistance.
qStandard EN 378 specifies that the room in which you install
your appliance must have a volume of 1 m2 per 8 g of R
600a refrigerant used in the appliance. If the room in which
the appliance is installed is too small, a flammable gas-air
mixture may form in the event of a leakage in the refrigera-
tion circuit. The quantity of refrigerant used in your appliance
is indicated on the type plate on the inside of the appliance.
uDetach the connecting cable from the rear of the appliance,
removing the cable holder at the same time because other-
wise there will be vibratory noise!
uRemove the protective film from the outside of the appli-
ance.
NOTICE
The stainless steel doors are provided with a high-quality
surface coating and must not be treated using the accompa-
nying care product.
Otherwise the surface coating will be affected.
uWipe the coated door surfaces using a soft, clean cloth
only.
uApply a stainless steel cleaner only to the stainless steel
side walls evenly, wiping with the grain. Subsequent
cleaning becomes easier as a result.
uWipe side walls with a paint finish using a soft, clean
cloth only.
uRemove all transit supports.
uDispose of packaging material (see 4.3) .
uMount the appliances according to the separate installation
instructions.
Note
uClean the appliance (see 6.3) .
If the appliance is installed in a very damp environment,
condensate may form on the outside of the appliance.
uAlways see to good ventilation at the installation site.
4.3 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
uDo not allow children to play with packing material.
The packaging is made of recyclable materials:
-corrugated board/cardboard
-expanded polystyrene parts
-polythene bags and sheets
-polypropylene straps
-nailed wooden frame with polyethylene panel*
uTake the packaging material to an official collecting point.
4.4 Connecting the appliance
NOTICE
Risk of damage to the electronic control system!
uDo not use stand-alone inverters (conversion of d.c. to a.c./
three-phase) or energy saving plugs.
WARNING
Fire and overheating hazard!
uDo not use extension cables or multiple socket outlets.
The type of current (alternating current) and voltage at the
installation site have to conform with the data on the type plate
(see Appliance at a glance).
Connect the appliance only with a properly installed
socket outlet with earthing contact. The socket outlet
must be fused with 10 A or higher.
It must be easily accessible so that the appliance can
be quickly disconnected from the supply in an emer-
gency. It must be outside the area of the rear of the
appliance.
Keep to the distance measurements to the socket outlet.
uCheck the electrical connection.
uPlug in the power plug.
4.5 Switching on the appliance
Note
uThe appliances can be switched on and off independently of
each other.
Put the appliance into operation about 2 hours before first
loading food to be frozen.
Do not load food to be frozen before the temperature display
reads -18 °C.
4.5.1 Switching on the freezer compartment
uPress On/Off button, freezer compartment
Fig. 2 (1)
.
wThe temperature display of the freezer compartment and the
alarm symbol flash until the temperature is sufficiently low. If
the temperature is above 0 °C, dashes flash. If it is below,
the current temperature flashes.
4.5.2 Switching on refrigerator and BioFresh
compartment
uPress On/Off button, refrigerator compartment
Fig. 2 (10)
.
wThe interior light is on when the door is open.
wThe temperature display shines. Refrigerator and BioFresh
compartment are switched on.
Putting into operation
5
5

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Liebherr-SBSes7273

Zoeken resetten

  • ijsblokjes zijn onvolmaakt en vriezen aan elkaar,water in ijsblokken bakje vriest ze aan elkaar .
    Werkt anders normaal?
    Ook het gekoelde water heeft te warm volgens de klant.
    Frigo staat op +5 en diepvries op -18
    groetjes Gesteld op 16-3-2012 om 16:53

    Reageer op deze vraag Misbruik melden
    • Tjien ik heb dit ook ?? Heeft een jaar normaal gewerkt en nu merk ik eveneens dat de ik blijkbaar water heb in mijn bak waardoor de ijsblokjes aan elkaar vriezen. Ik heb wel de indruk dat de blokjes volmaakt zijn Geantwoord op 30-3-2012 om 10:07

      Waardeer dit antwoord (5) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Liebherr SBSes7273 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Liebherr SBSes7273 in de taal/talen: Engels als bijlage per email.

De handleiding is 0.46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Liebherr SBSes7273

Liebherr SBSes7273 Gebruiksaanwijzing - Nederlands - 14 pagina's

Liebherr SBSes7273 Gebruiksaanwijzing - Deutsch - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info