597564
5
Verklein
Vergroot
Pagina terug
1/10
Pagina verder
13
EN
Operating and control elements
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appli-
ance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating current/three-
phase current) or energy-saving plugs. Risk
of damage to the electronic control system!
Saving energy
- Always ensure good ventilation. Do not cover ventilation open-
ings or grille.
- Avoid positioning the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
- The energy consumption depends on the installation conditions,
e.g. the ambient temperature.
- Keep the time the appliance is open to a minimum.
- Store food logically.
- Keep all food properly packed and covered so as to avoid its
frosting up on the outside.
- Always allow hot food to cool to room temperature before placing
in the appliance.
- If there is a thick layer of frost in the appliance: defrost the appli-
ance.
Accumulated dust increases the energy consumption:
- Regularly clean the motor compartment ventilation openings to
keep them free from dust.
1
Temperature control
2
Operating lamp
3
Alarm lamp
4
Superfrost button
5
Superfrost lamp
Switching the appliance on and o
You are recommended to clean the appliance before switching
it on for the rst time (see "Cleaning").
To switch the appliance on
Connect the appliance to the mains > the appliance is switched on.
The green operating lamp comes on.
The red alarm lamp comes on.
The red alarm lamp goes out as soon as the freezer compart-
ment is cold enough.
To switch the appliance o
Pull out the mains plug or
set the temperature control to 0.
Important
When the temperature control is turned to "0", only the re-
frigeration system is switched o. Before cleaning, always
di s c o n n e c t t h e a p p l i a n c e f r o m t h e m a i n s . R e m ov e t h e p l u g .
Setting the temperature
Using a coin, turn the arrow on the temperature control to a set-
ting between 1 und 4.
When the control is turned to 4, the temperature inside the appli-
ance is at its lowest.
For long-term storage of frozen food a
temperature of at least -18°C is recommended.
If the chest is loaded up to a maximum of 300 mm below
the top level of the basket, the appliance can be set
to the 1 setting. This setting reduces the amount of
power consumed by your chest freezer even further.
The temperature should in any case be set so that if you place
a thermometer on the top of the frozen food it reads at least
-18°C.
Control elements
The red alarm lamp comes on if the temperature
in the freezer compartment is not cold enough.
This can be caused by:
a long power failure;
a fault in the appliance.
In each case, make sure food has not defrosted or perished.
The "Superfrost" lamp lights up when the "Su-
perfrost" facility is switched on for freezing large
quantities of fresh food (see "Freezing").
2 3 5
4
1
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Liebherr GT 6122 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Liebherr GT 6122 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,87 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Liebherr GT 6122

Liebherr GT 6122 Gebruiksaanwijzing - Nederlands - 7 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info