214280
35
Verklein
Vergroot
Pagina terug
1/62
Pagina verder
Appendix A. Maintenance
This chapter describes how to clean the lens, replace the projection lamp, and use
the security lock.
Cleaning the lens
To clean the lens:
1. Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
Avoid using an excessive amount of cleaner. Do not apply the cleaner directly
to the lens. Abrasive cleaners, solvents, or other harsh chemicals might scratch
the lens.
2. Lightly wipe the cleaning cloth over the lens in a circular motion. If you do not
intend to use the projector immediately, replace the lens cap.
Replacing the projection lamp
The lamp hour timer in the About menu counts the number of hours the lamp has
been in use. After 2,980 hours, the message “Change lamp” briefly appears on the
screen at each startup. When the timer reaches 3,000 hours, the lamp will no longer
light. You can order new lamp modules from your dealer.
To change the projection lamp:
1. Turn off the projector and unplug the power cable.
2. Wait 60 minutes to allow the projector to cool thoroughly.
3. Turn the projector upside down and remove the lamp door by removing the
two screws and sliding the lamp door tabs out of the three tab bays.
CAUTION:
Never operate the projector with the lamp door removed. This disrupts the
air flow and causes the projector to overheat.
4. Loosen the captive screw on the lamp module.
CAUTION:
v This product contains a Metal Arc lamp which contains Mercury. Dispose
of as required by local ordinances and regulations.
v To avoid burns, allow the projector to cool for at least 60 minutes before
you replace the lamp.
v Do not drop the lamp module. The glass may shatter and cause injury.
v Do not touch the glass lamp screen. Fingerprints can obscure projection
sharpness.
v Be extremely careful when removing the lamp housing. In the unlikely
event that the lamp ruptures, small glass fragments may be generated.
The lamp module is designed to contain most of these fragments, but use
caution when removing it.
5. Carefully remove the lamp module by grasping and lifting the metal bail wire.
Dispose of the lamp in an environmentally proper manner.
6. Install the new lamp module, making sure that it is properly seated.
7. Tighten the single screw.
© Copyright IBM Corp. 2003 25
35

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Lenovo ilc300 conference room bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Lenovo ilc300 conference room in de taal/talen: Engels als bijlage per email.

De handleiding is 1,26 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info