POWER ON AND OFF
SLIDE THE POWER SWITCH TO THE "ON" OR "OFF" POSITION TO TURN THE UNIT ON OR OFF.
ANTENNA
FOR FM RECEPTION LAY OUT THE EXTERNAL FM WIRE ANTENNA AND ADJUST DIRECTION, FOR
OPTIMUM RECEPTION.
DO NOT CONNECT THIS WIRE TO ANY OUTDOOR ANTENNA .
PREPARATION
PLUG THE AC POWER CORD INTO AN AC OUTLET . THE CLOCK DISPLAY SHOWS FLASHING . THIS IS
A NORMAL CONDITION THAT WARNS THE USER THE TIME SHOWN IS INCORRECT . FLASHING CLOCK
DISPLAY ALSO APPEARS AFTER A POWER INTERRUPTION IF THE BACKUP BATTERY IS EXHAUSTED
OR NOT INSTALLED .
POWER SUPPLY
GB 2
OPERATION WITH AC POWER
1. PLEASE CAREFULLY CHECK THAT THE VOLTAGE INDICATED ON YOUR SET CORRESPONDS TO
THE VOLTAGE OF YOUR LOCAL AREA.
2. INSERT THE AC POWER CORD INTO AN AC OUTLET.
NOTE : WHEN INSERTED A BACK UP BATTERY THE UNIT WILL CONSERVE THE SETTINGS DURING
POWER OUTAGE.
THE DISCONNECT DEVICE SHALL REMAIN READILY OPERABLE.
BATTERY BACKUP
THE CLOCK TIME AND ALARM SETTINGS CAN BE PROTECTED AGAINST POWER FAILURE BY A 9V
BATTERY ( NOT SUPPLIED ) . IN THE EVENT OF A POWER FAILURE , THE DISPLAY IS BLANK , BUT
THE CLOCK TIME AND ALARM SETTINGS ARE HELD IN MEMORY. WHEN THE POWER INTER-
RUPTION ENDS, THE DISPLAY APPEARS AGAIN . ( DURING A POWER INTERRUPTION , THE CLOCK
TIME MAY GAIN OR LOSS A FEW MINUTES PER HOUR AND MAY REQUIRE RESETTING . )
BATTERY INSERTION
1 . REMOVE THE COVER OF THE BATTERY COMPARTMENT ( ON THE BOTTOM OF THE UNIT).
2 . CONNECT A 9V BATTERY ( AN ALKALINE - TYPE BATTERY IS RECOMMENDED ) TO THE
BATTERY TERMINAL INSIDE THE COMPARTMENT .
3 . PLACE THE CONNECTED BATTERY IN THE COMPARTMENT AND REPLACE THE COVER .
FOR OPTIMUM PERFORMANCE , THE BATTERY SHOULD BE REPLACED EVERY 6 MONTHS.
FITTING THE BATTERIES
THE RADIO
RADIO OPERATION
1 . SET THE POWER SWITCH TO ON TO TURN THE RADIO ON .
( TO TURN THE RADIO OFF , SET THIS SWITCH TO OFF . )
2 . SET THE FUNCTION SWITCH TO SELECT THE FM BAND.
3 . ADJUST THE TUNING CONTROL TO SELECT THE DESIRED RADIO STATION .
4 . ADJUST THE VOLUME CONTROL TO SET THE VOLUME TO THE DESIRED LEVEL .
