677504

Laica BC2002 Handleiding

7
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
14 15
3) Place the parent unit on a flat and solid surface and within the range of the baby
unit.
4) To activate the parent unit, press the "O/I" button for two seconds. The noise
indicator and connection indicator lights will flash once. The connection light will
then come on. This means the parent unit is connected to the baby unit. At this
point, the audio level can be adjusted by pressing the “▲” or “▼” buttons. Each
time a sound or noise is detected, the green noise detection light on the parent
unit will light up.
5) After turning on the two units, always check the parent unit reception, making sure
signal reception is possible where you wish to position it. We recommend checking
the reception with the help of a family member who will speak into the baby unit
while the other adult will make sure that the parent unit correctly receives the sound
from the room where the baby unit is located. This check should be performed
with the parent unit located in the rooms where you expect to position it to check
proper signal reception. If the parent unit loses its connection with the baby unit,
the green connection light will start to flash. To reconnect the two units, follow the
instructions in the paragraph "Problems, causes and solutions".
6) When not in use, always unplug the adapters and then disconnect them from the
parent and baby units. The parent unit can be located using the baby unit. With the
device on, hold down the " " key for a few seconds. If the parent unit is on it will
beep. To turn the signal off, press any button on either of the units. This function
can also be used to simply call whoever is within hearing range of the parent unit
FUNCTION: “NO EMISSIONS”
The baby unit has a special transmission technology that can be selected using the
ON/OFF switch (no. 5) on the bottom of the device.
When the switch is in the "ON" position, if the baby monitor is in stand-by mode and
does not detect any noise, the baby unit will not transmit any radiation. Attention!
When the function is activated, as soon as the baby unit detects a noise it transmits
a signal to the parent unit in order to re-establish connection between the two units.
This operation may take up to 8 seconds. When the switch is on "OFF" the connection
between the two units is continuous.
CLEANING AND MAINTENANCE
Before cleaning or performing any maintenance, turn the device off, unplug it and
remove the rechargeable batteries from the parent unit.
Do not immerse the baby unit, parent unit or adapters in water. Clean the outside
with a dry cloth. Do not use chemicals or abrasives. Make sure the units are dry
before plugging them in.
If not using the audio baby monitor for a long period of time, remove the batteries from
the parent unit. Store the baby and parent units and adapters in a cool, dry place.
TROUBLESHOOTING
PROBLEMS CAUSES AND SOLUTIONS
The baby/parent unit does
not come on
• Make sure the baby unit is plugged in
• Make sure the rechargeable batteries are installed in the parent unit. The
batteries may be low or not inserted correctly. Make sure they are inserted
correctly, place the parent unit in the charging base and proceed with
recharging.
The units do not connect. • The baby unit may be too far from the parent unit or there may be too
many walls between the devices. Change the positions of the units or
bring them closer together. If the two units must be reconnected, proceed
as follows:
1) Turn off both units
2) Turn on first the baby unit and then the parent unit. The connection
between the two units is active when the green connection light stops
flashing.
The parent unit emits a
high-pitched noise
• Make sure the units are not too close together. Move the parent unit away
from the baby unit or lower the volume on the parent unit.
There is interference, you
can hear only occasionally.
• The parent unit detects signals from other units or other baby monitors.
Move the parent unit away from other electrical devices like microwave
ovens or telephones.
• The units are out of reach. Move the units closer together.
• Make sure the batteries in the parent unit are not dead. Plug in the parent
unit and recharge.
Nothing is heard on the
parent unit even though
the green connection light
is steady and not flashing.
• Make sure the parent unit volume is not too low.
• The units are out of reach. Move the units closer together.
The operating range is less
than 300 metres.
• The 300 metre operating range is only valid outside. The number, type
of walls and/or ceilings between the two units affect the range inside
houses. To improve it, move one or both units.
GB
English
AUDIO BABY MONITOR
The batteries on the parent
unit are draining quickly.
• Make sure the volume on the parent unit is not too high as this uses more
energy. Rechargeable batteries get used up slightly on each recharge.
When you notice that the parent unit must be recharged often, replace
the rechargeable batteries.
TECHNICAL CHARACTERISTICS
Parent and child unit adapter:
Input: 100~240 V AC, 50/60 Hz, 150 mA
Output 7V DC, 100mA 0.42VA
Parent unit batteries: rechargeable type AAA 1.2 V 750 mAH NiMH A
Operating frequency: 1.8 GHz
Operating range: 300 metres outside, 50 metres inside
Parent unit operating time (with batteries completely charged): about 10 hours.
Important! Read the instructions carefully
This product is meant for domestic use.
The conformity, certified by the CE-marking on the device, refers to the
EEC Directive 2004/108 on electromagnetic compatibility and to the EEC
Directive 2006/95 on electric material destined to be used within given voltage
limits. This product is an electronic device that was tested to assure, according to
the current technical knowledge, that it does not interfere with other nearby located
equipment (electromagnetic compatibility) and that it is safe if used according to the
advices given in the instructions for use.
In case of operation anomalies, do not keep using the device and, if necessary, refer
to the manufacturer directly.
DISPOSAL PROCEDURE (Dir. 2012/19/Eu-WEEE)
The symbol on the bottom of the device indicates the separated collection of
electric and electronic equipment.
At the end of life of the device, do not dispose it as mixed solid municipal
waste, but dispose it referring to a specific collection centre located in your
area or returning it to the distributor, when buying a new device of the same type to
be used with the same functions.
If the appliance to be disposed of is less than 25 cm, it can be returned to a retail
location that is over 400 m² without having to purchase a new, similar device.
This procedure of separated collection of electric and electronic devices is carried
out forecasting a European environmental policy aiming at safeguarding, protecting
and improving environment quality, as well as avoiding potential effects on human
health due to the presence of hazardous substances in such equipment or to an
improper use of the same or of parts of the same.
Caution! The wrong disposal of electric and electronic equipment may involve
sanctions.
WARRANTY
This equipment is covered by a 2-year warranty starting from the purchase date,
which has to be proven by means of the stamp or signature of the dealer and
by the fiscal payment receipt that shall be kept enclosed to this document.
This warranty period complies with the laws in force and applies only in case the
consumer is an individual. Laica products are designed for domestic use only;
therefore, their use for commercial purposes is forbidden.
The warranty covers only production defects and does not apply, if the damage is
caused by accidental events, misuse, negligence or improper use of the product. Use
the supplied accessories only; the use of other accessories invalidate the warranty
cover. Do not open the equipment for any reason whatsoever; the opening or the
tampering of the equipment, definitely invalidate the warranty.
Warranty does not apply to parts subject to tear and wear along the use, as well as to
batteries, when they are included. Warranty decays after 2 years from the purchase
date. In this case, technical service interventions will be carried out against payment.
Information on technical service interventions, under warranty terms or against
payment, may be requested by writing at info@laica.com. Repair or replacement of
products covered by the warranty terms are free of charge. In case of faults, refer to
the dealer; DO NOT send anything directly to LAICA.
All interventions covered by warranty (including product replacement or the
replacement of any of its parts) shall not be meant to extend the duration of the
original warranty period of the replaced product. The manufacturer cannot be made
liable for any damages that may be caused, directly or indirectly, to people, things
and pets resulting from the inobservance of the provisions contained in the suitable
user manual, especially with reference to the instructions related to installation,
use and maintenance of the equipment. Being constantly involved in improving
its own products, Laica reserves the right to modify its product, totally or partially,
with reference to any production need, without that this involves any responsibility
whatsoever by Laica or its dealers.
GB
English
Instructions and guarantee
… 7 …

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Laica BC2002 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Laica BC2002 in de taal/talen: Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 1,62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info