677501
6
Verklein
Vergroot
Pagina terug
1/18
Pagina verder
12 13
ELECTRIC STEAM STERILISER
BEFORE USING THE PRODUCT, IT IS IMPORTANT TO READ THE
INSTRUCTIONS AND WARNINGS CONTAINED IN THIS BOOKLET
CAREFULLY. PRESERVE THIS BOOKLET WITH CARE.
Taking care of newborns requires utmost hygiene of the necessary accessories
for nursing since poor attention to this may result in stomach ache or diarrhoea.
Among the household methods applied for assuring a suitable hygienic level,
the use of heat is surely the most interesting one.
By means of the steam generated by a hot source, it is possible to reach
such a cleanness level allowing considering most of the germs noxious for
newborns eliminated.
Assuming this, LAICA offers a simple and safe system for sterilizing feeding
bottles and all their components.
Your new sterilizer can sterilize up to 6 bottles in about 10 minutes.
It is equipped with an internal basket for sterilizing teats.
The device is equipped with a dosing measuring scoop and hygienic tweezers
to handle the sterilised accessories.
Mains operation.
GENERAL WARNINGS
The use of any electric device involves the respect of some essential rules:
Disconnect the plug from the power outlet immediately after use, and in
any case always before cleaning it and before inserting or removing the
accessories.
Do not pull the power supply cable or the device itself to disconnect the
plug from the power outlet.
If an electric device falls into water do not attempt to reach it, but rather
immediately disconnect the plug from the power outlet.
• Never immerse the device in water or other liquids.
• Never let the device work unattended and do not allow children, invalid or
disabled people to use it.
This device shall be used only for the use destination for which it was
designed, and in the way described in the instructions for use.
Any other use is to be considered improper and therefore dangerous.
The manufacturer cannot be made liable for any damages resulting from
improper or wrong use.
• Before use, make sure that the device is integral, without visible damages.
In case of doubt, do not use the device and refer to the own dealer.
In case of fault and/or malfunction, immediately switch off the device without
tampering it.
For the repairing, always refer to the own dealer.
• Keep the device away from heat sources.
Make sure to have dry hands when inserting and removing the plug and
when acting on the ON/OFF key.
This device has to be used only with the voltage values given on the bottom
of the product.
Do not leave the device exposed to weathering (rain, sun, etc.), high
temperatures or close to computers or other electronic devices.
• To avoid dangerous overheating, it is recommended to unwind the power
supply cable for its entire length.
• Disconnect the plug from the power outlet when the device is not in use.
Caution! Do not intervene for any reason whatsoever on the electric cable.
In case of damage, refer to the own dealer.
SPECIAL WARNINGS
When operating, the sterilizer contains boiling water and steam
that comes out from the cover. Watch out in order to avoid burns.
Place the device on a flat, rigid and water-proof surface; keep the power
supply cable away from heat sources.
• Do not open the unit when it is working in order to avoid burns.
Do not use the steriliser without water; use only cold tap water without
adding any essence, perfume, medicine or other substances.
• Do not sterilise metal objects.
Do not cover or insert objects into the openings of the steam steriliser (e.g.
into the steam outlet hole on the cover, into the bottom of the device).
• Caution! This is not a toy, but a household steam steriliser.
Do not leave the device unattended also when it is not used.
GB
DEVICE PARTS
1. Steriliser unit
2. Water container
3. O/I light
4. Steriliser unit cover
5. Teat and bottle holding basket
6. Dosing measuring scoop
7. Hygienic tweezers
8. Power supply cable
INSTRUCTIONS FOR USE STEAM STERILIZER:
Before using the steriliser for the first time:
1) Place the device on a flat and stiff surface.
2) Assemble the teat and bottle holding basket according to figure 1. Insert
and embed the appropriate supports to the base as shown in fig. 1a, 1b
and 1c.
3) Pour exactly 60 ml of cold tap water into the device water tray using the
measuring scoop included in the supply (figure 2).
4) Place the basket and the hygienic tweezers into the steriliser (see figure
3). Close the cover.
5) Connect the plug and press the O/I button.
The O/I light turns on (red).
Caution! If the O/I light turns on immediately after you insert the plug, it
means that the O/I button was accidentally pressed before connecting the
plug. In this case, the device starts automatically the sterilization cycle.
Do not turn the device on, if the water tank in the base has not been filled
first.
6) After each sterilisation cycle, the red light switches off indicating that the
sterilisation has ended.
In any case, switch off the device disconnecting the plug from
the outlet.
7) Let the steriliser cool down for few minutes, open the cover, extract the
teat basket and the hygienic tweezers, remove any excess water from
inside the steriliser unit, drying the same with a clean cloth. Now your
new steam steriliser is ready for use.
Caution! Before performing the steam sterilisation, verify that the
baby bottles and nursing accessories can be boiled.
The steam steriliser can sterilise up to 6 baby bottles simultaneously.
1) Place the device on a flat and stiff surface.
2) Pour exactly 60 ml of cold tap water into the device water tray using the
measuring scoop included in the supply (figure 2).
Caution! If a greater quantity of water is poured, the sterilisation cycle may
last longer; if the quantity is lower, the sterilisation may be ineffective.
3) Place the baby bottles upside down in vertical position inside the steriliser
leaning them on the lower tray of the bottle holding basket (figure 4) and
place the related teats or any small parts to be sterilised on the upper basket.
Place the hygienic tweezers on the upper tray among the teats.
Close the cover.
Caution! Wash all baby bottles and accessories with non-foamy
soap carefully and rinse them with plenty of water before each
sterilisation cycle.
4) Connect the plug and press the O/I button.
The O/I light turns on (red).
Caution! If the O/I light turns on immediately after you insert the plug, it
means that the O/I button was accidentally pressed before connecting the
plug. In this case, the device starts automatically the sterilization cycle.
Do not turn the device on, if the water tank in the base has not been filled
first.
5) After few minutes, steam comes out from the hole on the cover, watch out
to avoid burns.
6) After about 10 minutes, the red light switches off: the sterilisation has ended.
In any case, switch off the device disconnecting the plug from
the outlet.
7) Do not remove the cover immediately; let the steriliser cool down for few
minutes.
8) Wash your hands carefully before picking up the sterilised products.
9) Open the cover, take the hygienic tweezers that can be used to pick up the
sterilised teats and place them on the baby bottles.
GB
English English
Instructions and guarantee
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Laica BC1005 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Laica BC1005 in de taal/talen: Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 0,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info