INSTALLER’S MANUAL
Changing the gas type
Hob injector:
► Lift the air ring D.
► Replace the injectors E in accordance with table 5 in appendix 0 and figure 【7】 ( Ø in 1/100
mm).
If necessary, the mixer tubes of the lateral burners maintained by a cross-bar H, (H, fig.【10】) may
be released.
To release the tubes loosen screws F (fig.【8】) and then screw (G, fig.【9】).
N.B. When replacing injector(s), also replace the sealing washer (see paragraph “Gas Line”).
Adjusting the primary air of hob burners :
► Position the burner bodies and ame diffusers in their respective locations.
► Adjust the air ring F (see fig.【3】and 【8】, tabel 6 in appendix 0).
N.B: Normal ames are bluish green except for natural gas ames which are violet.
Lacanche ranges are supplied with the gas tting requested when the order is placed. The settings
must be ne-tuned when the range is installed.
The appliance is designed to operate with the gases in table 4, appendix 0.
IMPORTANT : Close the mains gas valve before carrying out any works.
IMPORTANT
In case of use with a gas other than that for which the appliance was initially set up, it is
crucial to replace the injectors and modify the adjustments as dened below.
Size 2 wrench
【7】
E
Size 2 wrench
【8】
F
【9】
G
【10】
H
D
CHANGE OF GAS
