Tuning and adjusting TV stations manually
You may prefer to tune your television manually. Manual tuning can be more effective if the television signal in your area is too
weak for the ACMS to work properly. You can also fine tune your channels and customise the channel names.
6
Manual tuning
1 Turn on your television and your
Video Recorder. Select the video
channel on your television and
press to access the main
menu.
2 Press either 1 or 2 to select PR
SET then press OK.
3 Press again and the television
channel table will then appear.
4 Use the 3 or 4 buttons to select
the program number you want to
tune then press OK.
5 Select the CH section (if not
already selected) by using the 1
or 2 buttons and then use the 3
or 4 buttons to move through the
channel numbers to find the
required station.
6 The station can be fine tuned to
improve picture quality. Select
MFT (Manual Fine Tuning) using
the 1 or 2 buttons. Use the 3
or 4 buttons to adjust the picture.
7 Select STATION by pressing 2 you
can then name your station.
If the station transmits PDC the
station name will be added
automatically.
8 Press OK to reveal the television
station name list. Use the 3 or 4
buttons to select a station name
from the list. Press OK to select it.
If the name you require is not on
the list see Customising channel
names opposite (Start from step
No. 5).
9 To confirm the station placement
press .
10 Press again to remove the
menu.
11 The new station has now been
red into your Video Recorder.
If you wish to manually tune other
channels you should repeat the
above procedure.
To move the manually tuned channel
to it’s correct position see Changing
the order of the television stations
on page 5.
If it is necessary for you to tune all
the television stations manually you
may find it easier if you write the CH
numbers down for each station as
you find them. You can then select
each channel from the main menu
and type the CH numbers in directly.
Each channel will then be in the
correct position so there is no need
to change them later.
Customising channel
names
If the station name you require isn’t
listed you can insert one manually
instead of using the templates.
1 Press to access the main
menu. Use 1 or 2 to select PR
SET then press OK.
2 Press again then use 3 or 4 to
select the programme number you
wish to customise station name.
3 Press OK.
4 Press 2 to go to STATION and
then press OK.
5 Then press 2, a flashing bar
appears beneath the first letter.
6 Use 3 or 4 to select letters and
numbers for the new station name
up to a maximum of 5.
7 Press 1 or 2 to move between
the characters.
8 Press OK.
9 To confirm the new position
press .
10 Press again to exit the menu.
11 The new station name is now
stored in your Video Recorder.
