OPERATIONS(water dispenser)
26
Putting The Water In The Water Tank
Drinking
1
Turn the lock dial in the direction of the arrow as
shown to remove it and pour water into the
dispenser water tank.
2
Close the cap by tilting it and putting one side in
first and then the other side as shown.
3
Place the water tank in the tank holder inside
the refrigerator. Make sure that the groove on
the connecting part is in position with the tab.
Push the connecting part into the hole unit it
“Clicks”.
4
Fix the connecting part in place by means of
the holder ring as shown.
• Do not use anything other than water including soft drinks, milk and juice.
• Hot water needs to be cooled before being put in the water tank.
• Always use the holder ring to fix the water tank in place to prevent the tank from moving or
getting loose.
1
Press the dispenser pad with the glass.
2
The water is released when the dispenser pad
is pressed. The pad returns to its original
position when the glass is removed, and the
water stops its flow.
CAUTION
• The motor rotates in reverse for a few seconds after the dispenser is released to dispose of
any water remaining in the tubes.(This may cause the sound of water being sucked back
inside)
NOTE
Tab
Groove
