❏
Auto Clean function remove moisture in indoor units after cooling operation(cooling, healthy dehumidification,
auto operation cooling, auto changeover cooling)
1. Press the AUTO CLEAN BUTTON to activate this function.
2. Now whenever the unit is turned off, the indoor fan is still running for about 30
minutes internally without cooling or dehumidification operation. Also the louver is
closed.
3. This dries up any remains of moisture & cleans the unit internally.
4. If you press AUTO CLEAN BUTTON again during operation, this function is
cancelled.
Auto Clean
Jet Cool function can be used to cool the room quickly in hot summer. When this
function is turned on, the air conditioner runs in cooling operation mode with super
high fan speed and 18°C setting temperature for 30 minutes for fast and effective
cooling.
Similarly,Jet Heat function (available only in some models) warms up the room quickly
by operating at super high fan speed and 30°C setting temperature for 30 minutes.
You can activate this operation by pressing the JET COOL/HEAT BUTTON.
To change from Jet Cool mode to high fan speed cooling mode, press the JET COOL/HEAT BUTTON or
INDOOR FAN SPEED SELECTOR BUTTON or the ROOM TEMPERATURE SETTING BUTTON again.
• Jet Cool/Heat operation cannot be activated during Air Circulation operation, Auto operation and Auto
changeover operation.
• Jet Heat operation cannot be activated when wired remote controller is connected.
• You can use Jet Heat function by pressing JET COOL/HEAT BUTTON in heating operation.
